Read the sides. Put inputs left and right in the correct slots. you can get input from speaker wire coming from speakers already in your car that is hooked in to the radio or amp. Then run wires to the speakers
adjustments and audio settings
You need to turn on your Bluetooth in mobile and then pair your mobile with car audio system. After pairing you can listen your phone audio through car audio system.
First off power caps are useless in big car audio, but small is fine. Now the way to hook it up is the power wire coming from the front of your car goes to the + side of the cap then another wire will go on the + side of the cap and go to the amp. The ground of the cap can go striaght to the car by way of self tap screw.
To hook up a crossover to an amplifier, first, connect the output from the amplifier to the input terminals of the crossover using speaker wire. Then, connect the crossover's output terminals to the appropriate speakers, ensuring that the connections correspond to the correct frequency ranges (e.g., high-pass for tweeters, low-pass for woofers). Finally, ensure all connections are secure and double-check the polarity to avoid phase issues.
Coaxial
Only if your projector has two inputs,hook up the output video/audio of VCR into the input video/audio of the projector. Radio Shack sells switchers to do this very function.
You can hook up any cassette player to your PC by connecting the 2.5 mm audio out to your PC.
I suppose you are talking about one to an amp. If so, you have to hook up a positive from one side to the negative of the other.
Yes, you can hook up a car seat to the Ford Expedition
You can usually hook up your TV to your computer via a S-Video cable, though you'll also need to hook up audio as well.
When jumping a car, you should hook up the red cable first.
The familiar red and white RCA jacks are needed to hook your Direct TV receiver up to an audio source.In general you'll need a stereo receiver to hook it up to speakers.You do get superb audio from DTV so it's worth the trouble.