Unless you see any cracks etc in the rim itself Take it to a tire shop or garage and have it spin balanced...May just need to be balanced, Chuck
cause your intake valve is bent You probably have a bad tire or rim. I'd go with the tire or rim answer.
The tire may be bad The rim may be bent The tire and rim may be out of balance The wheel hub and bearings may be bad The tie rods may be bad Have it checked soon!
the last # on your tire is the size rim you need for that tire 295 50 15 /15 inch rim I am sure you know it must be a 15" rim and were asking about the width of the rim. You need at least a 9" wide rim but a 10" would be even better to avoid tire bulge.
Bad tire? Bent rim? Bad wheel bearing? Try moving tire to another location on the vehicle and see if problem moves with tire
Take the tire and the rim to a tire shop. It requires special equipment to properly replace the tire and balance the rim.
Bad tire? Bent rim?
of course it will pop the tire if it haasnt already
To get a tire back on a rim, you can use tire irons or a tire changing machine to carefully pry the tire onto the rim. Start by lubricating the tire bead and rim with soapy water to make it easier to slide the tire on. Use the tire irons to gradually work the tire onto the rim, being careful not to damage the tire or rim. Once the tire is on, inflate it to the recommended pressure and check for any leaks.
To remove a tire stuck on a rim, you can use a tire iron to pry the tire off the rim. Start by loosening the lug nuts, then lift the tire and rim off the ground. Use the tire iron to carefully pry the tire off the rim, working your way around the tire until it is completely removed. Be cautious and patient to avoid damaging the tire or rim.
To remove a tire stuck to a rim, you can use a tire iron or pry bar to carefully separate the tire from the rim. Start by loosening the lug nuts, then use the tire iron to pry the tire away from the rim. Be cautious not to damage the rim or tire in the process. If the tire is still stuck, applying lubricant around the edge of the rim can help loosen it.
To properly seat a tubeless tire on a rim, follow these steps: Ensure the tire and rim are clean and free of debris. Apply tire sealant to the tire bead and rim. Place the tire onto the rim, starting at the valve stem. Use a tire lever or compressor to help seat the tire onto the rim. Inflate the tire to the recommended pressure and check for leaks. If necessary, adjust the tire pressure and re-seat the tire until it is properly seated on the rim.
The rim popped out of the tire because of a sudden increase in pressure or impact that caused the tire to lose its seal with the rim, leading to the rim coming out.