To light a catalytic heater, first ensure that the unit is properly set up in a well-ventilated area. Turn the control knob to the "Pilot" position and press it down to allow gas to flow. While holding the knob, use a long lighter or match to ignite the pilot light. Once lit, continue holding the knob for about 30 seconds, then release it and turn the knob to the desired heat setting.
A catalytic heater can be purchased from most hardware stores and a few mass department store retailers. Prices range from $40 to roughly $100 depending on the size and brand desired.
You will have to install a catalytic converter to get the light to go off.
A failed catalytic converter is one of hundreds of parts that can cause the check engine light to be on.
No, that would have no effect on the heater system.
A light bulb similar to a heater in that they both produce heat when in operation.
Yes, the overhead heater controls do light up.
Yes, 1977 light trucks are factory equipped with catalytic converters.
If the car is buit after 1996 you will need to install a new catalytic converter to get check engine light to go out if the code is for the cat.
Check engine light, low power, poor fuel economy, highly illegal to run without the catalytic converter.Check engine light, low power, poor fuel economy, highly illegal to run without the catalytic converter.
you will get the check engine light on and not pass the dEQ
This light is indicating a emissions problem or failure. The catalytic converter may be operating at low efficiency which is a sign of failure.
To determine if the water heater pilot light is out, locate the pilot light access panel on the water heater. Look inside to see if the pilot light is lit. If it is not lit, you may need to relight it following the manufacturer's instructions.