0
To program a Python 476P car alarm remote, first, ensure the vehicle is in the "off" position and the alarm system is installed correctly. Then, insert the key into the ignition and turn it to the "on" position without starting the engine. Press and hold the "program" button on the alarm system while pressing the button on the remote you wish to program. Release both buttons, and the system should confirm successful programming with a sound or indicator light. Follow any specific instructions from the user manual for additional settings or features.
What else can I help you with?
Related Questions
Trending Questions
Where is the transmission dipstick for a 1987 LS Acura?
Would code 43 electronic spark control failure cause the vehicle to not start and would replacing the knock sensor fix this or is it an ECM issue?
What wrenchl for caliper bolts 2000 mystique?
Can you mix 10w40 with 15w40 engine oil?
How do you know when your dodge stratus battery is dead?
How much cost to replace cv joint on 2001 Altima?
Proper spark plug for 327 Chevy?
What is the horn location on a 2000 Hyundai Elantra?
Is timing belt on Kia 2004 optima covered under the power train warranty?
Where is the starter for a 2000 Chevy Cavalier?
What causes Jenn-air range model w146-c intermittent buzzing noise?
What is a simple gear with idler?
How do you change the brake light on a 2005 Hyundai Tucson?
What does it mean when engine light is blink on and off?
Why wont your heater change from feet to defrost but blows out hot air still?
How much oil in Briggs and stratton 17 hp engine?
How do you replace a rocker cover gasket for a daewoo nubria?
How long does it take to change the head gasket on '95 ford windstar?
How do you install capacitor to amp?
Where is the fuel pump located on a 1993 bronco?
Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.