1. Remove the rear seat cushion 2. Remove the fuel pump access cover 3. Disconnect the fuel pump electrical connector 4. Start the engine and wait for it to stall. After it stalls, turn the ignition off. Any residual fuel pressure in the fuel system is now relieved
Parts from a Hyundai Elantra may not be directly compatible with a 2000 Hyundai Elantra wagon due to differences in design and specifications between model years and body styles. While some components might be interchangeable, it's essential to verify compatibility for specific parts. Consulting a parts catalog or a professional mechanic can help ensure you select the right components for your vehicle.
there is two main things that will cause an elantra to have no spark the ignition coil pack or the crankshaft sensor
whosale parts warehouse in cali. www.partswarehouse.com
I checked my owner's manual - it listed radiator capacity at 6L.
there's no such thing as a Hyundai ''lantra'', its elantra If it's the same as Elantra try modifiedlife.com. They got free wiring diagrams for many makes and models. Sorry. There is a Lantra. It was released in Australia by Hyundai during the late 90s. There is a sedan and a sports wagon.
I've yet to change mine, but I hear that you specifically need to get Hyundai brand tranny fluid. Don't use generic.
CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Relieve the fuel system pressure * Disconnect the negative battery cable * If necessary remove the air cleaner assembly * Remove the clips and detach the hoses from the fuel filter then remove the filter bracket nuts and lift the assembly out of the engine compartment
The washer fluid containter is in the cargo compartment; I believe on the right hand side. There is a little compartment that contains the washer fluid reservoir.
they are up your azzz
check out hmaservice.com
the check engine light comes on for many reason or many parts usally emmision related.
Remove the inside panel from your Hyundai rear door. The wiper motor mechanism will be visible. Remove the wiper motor linkage. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new rear wiper motor.