It might be necessary to remove the outer nut and bearing to remove the drum. If it's just rusted on you'll need some WD 40 to get started and a BFH, or big freakin hammer. Bang the drum in the direction of the other side of the car, right at the perimeter of the drum while spinning it. The object is to ring it like a bell and vibrate the rust loose, works every time.
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
Remove the tire and wheel. Remove the spring from the brake shoe assembly. The brake shoe will come off. Reverse the process to install the new brake shoes.
there is no such car as a 1992 dodge avenger, so i guess you don't remove one.
Dot 3
The red brake light on the dash means that the brake fluid is low or the parking brake is on.
remove the caliper slider bolts and the brake hose then put the new caliper on, dont forget to bleed the new caliper and top off brake fluid when finished
It is inside the shifter assembly.
If I am not mistaking, the Dodge Avenger will be used in Car of Tomorrow races. The Regular Car Version will run the Charger, and the COT Version will be the Avenger the COT will run 16 races, the rest will be the old car races.
You have to remove the tranmission and the flywheel.
To remove the brake and signal light lens on a Dodge Avenger, first, ensure the vehicle is turned off and the keys are removed. Locate the screws or clips securing the lens assembly, typically found on the inside of the trunk or behind the tail light cover. Remove these fasteners using a screwdriver or appropriate tool, then gently pull the lens away from the vehicle. Disconnect the wiring harness if necessary, and the lens should come off easily.
How do you remove the rear brake rotor on a 2005 Dodge Ram 2500?
Dodge Avenger was created in 1995.