== ==
how do i remove the dashboard from my 2002 corvette to change the hud display there is a site that may help you www.spdkilz.com
== ==
The 2000 Chevrolet Corvette blower motor control module can be found behind the passenger side dashboard. You will need to remove the dashboard in order to access the module.
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
Coupe or convertible? Yet another un-specific question.
Remove the two screws that you can see in the indentation on the top of the dash. Then remove two screws under the lip of the dash. It will take a good pull but it will come off.
To remove the radio from the 1990 Lexus ES250, first pry the face plate from the dashboard. Then remove the clips that hold each side of the radio. Then, remove the wires to release the radio.
How do I remove the dashboard.
1980 corvette , how to remove speedometer
the 1990 corvette had the LT-1 motor 300bhp and 340fpt that is the correct answer to this question!
To be honest, it's alot of work. If you don't want to have to deal with trying to figure out where the vacuum lines go and don't have pacience to remove the dashboard, then take it to a Corvette Specialist to remove it. If you're up for it: remove dashboard, disconnect all vacuum lines attached to the air diverter....basically, you have to disconnect everything on the right side of the vehicle (including draining the coolant from the vehicle in order to disconnect the send and return hoses...) To be honest, it's alot of work. If you don't want to have to deal with trying to figure out where the vacuum lines go and don't have pacience to remove the dashboard, then take it to a Corvette Specialist to remove it. If you're up for it: remove dashboard, disconnect all vacuum lines attached to the air diverter....basically, you have to disconnect everything on the right side of the vehicle (including draining the coolant from the vehicle in order to disconnect the send and return hoses...)