answersLogoWhite

0

Place a block or jack stand under engine frame. Remove 2 swing arm bolts. 1 on each side. Remove upper shock bolts on each rear shock. De-tatch rear brake cable. Remove the hose clamp on the drive shaft rubber boot cover closest to the engine. Slide rear end out from under 4 wheeler. You can now pull drive shaft from rear housing.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you disconnect front drive shaft from a 2002 Kawasaki mule 2510?

To disconnect the front drive shaft from a 2002 Kawasaki Mule 2510, first, ensure the vehicle is on a flat surface and secure it with wheel chocks. Remove any necessary panels to access the drive shaft. Next, locate the two bolts securing the front drive shaft to the front differential and the other end to the transfer case, using the appropriate tools to remove them. Carefully slide the drive shaft out of the yoke to complete the disconnection.


Neutral gear switch sensor location 220 kawasaki bayou?

inside the output housing located just behind the pull start housing. look where the drive shaft attaches to the left side of the motor. it will have the shift pattern on it.


How do you change a Fiat Doblo drive shaft?

how to remove a drive shaft on a fiat doblo


How do you remove a drive shaft in 1999 Ford Taurus?

there is no drive shaft it's front wheel drive


Can the cam shaft sprocket move on the shaft on a 1995 kawasaki 400 bayou?

Yes, the camshaft sprocket on a 1995 Kawasaki 400 Bayou can move slightly on the shaft if it is not properly secured. Typically, sprockets are held in place by a key or bolt, and if these components are loose or worn, the sprocket may shift. However, any significant movement can lead to timing issues and should be addressed immediately to avoid engine damage. Regular maintenance and inspection can help prevent this issue.


Dodge Durango rear drive shaft removal?

How do you remove drive shaft from a 03 durango


How do you remove broken off flexible drive shaft from weedeater?

remove head pull shaft out


How do you remove front drive shaft on trx 350?

To remove the front drive shaft on a Honda TRX 350, first ensure the ATV is on a stable surface and disconnect the battery. Remove any necessary covers or components to access the drive shaft. Then, unbolt the drive shaft from the front differential and the gearbox, ensuring to note the orientation for reinstallation. Finally, gently slide the drive shaft out of its housing.


1948 ford drive shaft infohow do you remove the shaft.?

No proper man wants to be without his shaft


How do you replace a drive shaft center support bearing on a 2006 dodge ram megacab?

You must remove the rear drive shaft section and then remove the support.


How do you remove Kubota rtv 4x4 drive shaft?

To remove the drive shaft from a Kubota RTV 4x4, start by ensuring the vehicle is on a flat surface and securely supported. Disconnect the battery and remove any protective covers or shields from the drive shaft area. Loosen and remove the bolts securing the drive shaft to the transmission and rear differential, then gently slide the drive shaft out of its connections. Always consult the owner's manual for specific instructions and torque specifications related to your model.


How do you remove drive shaft from 94 pickup?

To remove the drive shaft from a 1994 pickup, first, ensure the vehicle is securely lifted and supported. Begin by marking the position of the drive shaft to maintain balance during reinstallation. Next, remove the bolts securing the drive shaft to the rear differential and the transmission, and then gently slide the drive shaft out of the yoke. Be cautious of any fluid leaks and inspect the universal joints for wear during the process.