you will have to explain a little more are you describing a fitting with a clip or just a clamped rubber line on a barb fitting? if a clamped fitting take pliers and grab on fitting enough to turn hose back and forth it will usually pop free. if with a clip fitting you have to take the lock clip out from behind the flange and it should release if not you may have to cut the fitting out and replace it if it is a metal line there should be two fittings you put two wrenches on and turn in opposite directions again if the are too tight you may have to pipe cut the line and splice with a rubber piece of fuel line
Yes, you can remove a stuck hose from a faucet by using lubricant, pliers, or a hose removal tool to gently twist and pull it off. Be careful not to damage the faucet or hose in the process.
To remove a stuck hose from a spigot, try twisting the hose gently while pulling it away from the spigot. If that doesn't work, you can try using lubricant or hot water to help loosen the connection. If the hose is still stuck, you may need to use pliers or a wrench to carefully loosen it. Be sure to turn off the water supply before attempting to remove the hose.
The hose may be stuck on the spigot due to a buildup of dirt, rust, or debris on the spigot's threads, or the hose may have expanded from the heat and become difficult to remove.
To remove a stuck hose, try twisting it gently while pulling it at the same time. You can also use a lubricant like soapy water to help loosen it. If it's still stuck, consider using pliers or a wrench for extra leverage. Be careful not to damage the hose or the connection while trying to remove it.
To safely remove a stuck hose from a spigot, try twisting the hose gently while pulling it away from the spigot. If that doesn't work, use a lubricant like soapy water or WD-40 to help loosen the connection. Avoid using excessive force or tools that could damage the spigot. If the hose is still stuck, consider seeking help from a professional plumber.
fuel intake hose is bad needs to be replaced
Drain all fuel from the tank (Or as much as possible) You will need to disconnect the negative battery cable. Remove the Gas Cap. Disconnect the fuel tank fill hose, and the vent hose from the fill neck diconnect the fuel pump module wiring harness and and anything securing the harness to the fuel hoses Disconnect the fuel tank vent hose from the vent tube Disconnect fuel supply hose at the pump Remove your skid plate. Remove tank shield support the fuel tank with a jack Remove the tank support strap nuts and separate the straps away from the tank Lower the jack and tank
Remove the hose from petcock check if fuel is flowing from it ok. If its not you have to clean out the tank. If its in the hose just replace the hose.
Remove the fuel tank. Disconnect the fuel hose from the fuel pump to the junction of the carbs. Disconnect the fuel hose from the fuel filter to the fuel tank. Remove the fuel filter bracket. Keep track of the position of the fuel filter. Remove the fuel filter from the rubber holder. Disconnect the fuel pump electrical connector. Remove the fuel pump from its holder bracket A large screwdriver may be necessary to pry pump away from the holder bracket. . Remove fuel pump assembly. Remove remaining hoses from fuel pump. Installation is reverse of removal.
you can syphon it using a hose and fuel can, with the fuel can lower than the tank
Drain the radiator and remove the hose and remove the clog. I suspect you have other problems if you think the hose is clogged. I would suspect the thermostat is stuck closed. Replace the thermostat and flush the system.
You have to remove the filler neck and hose from the tank then slip a siphon hose into the tank.