0
You must remove the black cross brace, then unhook the washer fluid sensor wire from the tank and lift the tank up, being careful not to pull the hose off. Push the tank towards the black fuse box. Then you can remove the clamp on top of the battery by removing the screws at each end.
What else can I help you with?
How do you replace the starter on a 1998 Monte Carlo z34?
Remove the positive cable from your 1998 Monte Carlo battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Replacing a back window on a Monte Carlo?
How do I remove the back window in a 1998 Monte Carlo? how do I replace this?How do I remove from other Car's model
How do you change a PCV valve on a 1998 Monte Carlo?
The PCV valve for a 1998 Monte Carlo should plug into the valve cover. Twist and pull it to remove and replace it.
How do you replace the ball joints on a 1998 Monte Carlo Z34?
How do you replace the ball joints on a 1998 Monte Carlo Z34??
Will 1998 s10 wheels fit 1998 Monte Carlo?
will 2002 monte carlo rims fit 2000 s10
What size battery is needed for a 1998 Monte Carlo?
Any place that sells batteries can tell you the correct size.
How do you install ignition cylinder lock for a 1998 Chevy Monte Carlo?
To install the ignition cylinder lock on a 1998 Chevy Monte Carlo, first disconnect the battery to ensure safety. Remove the steering column covers by unscrewing them, then locate and remove the ignition switch. Insert the new ignition cylinder into the switch, ensuring it aligns properly, and reassemble the steering column covers. Finally, reconnect the battery and test the ignition to ensure it functions correctly.
What size torx wrench to remove front calipers 1998 Monte Carlo?
The T60 is the size needed to remove caliper bracket.
How do you get the thermostat out in a 1998 Monte Carlo?
you have to remove the throttle body and use 13mm rench to take the thermostat housing bolts off
What is the top speed for the 1998 Monte Carlo?
On my 95 Monte Carlo Z-34, the top speed was 114 and started to cut out at 115.
How do you remove headrest 1998 Chevy Monte Carlo?
To remove the headrest from a 1998 Chevy Monte Carlo, first, locate the release buttons on the sides of the headrest support posts. Press these buttons simultaneously while pulling upward on the headrest to remove it. If the headrest doesn't come off easily, ensure that the buttons are fully pressed in. Once the headrest is free, you can lift it out of the seatback.
Where is the distributor located on a 1998 Monte Carlo z34?
It doesn't have a distriburetor.
