0
To start pull down the glove box and you will find two Phillips screws you will need to undo these.
On the drivers side underneath the steering column there is a little pocket pull the pocket down and there are two Phillips screws you will need to unscrew these.
Underneath the pocket by the pedals there are four Phillips screws you will need to unscrew these and the plastic will release.
Remove the gear knob by unscrewing,then pull the plastic surround around the gear knob and handbrake.carefully remove the wires for the cigarette lighter then pull panel clear.
With a straight screwdriver you will need to remove the heater switch by the stereo carefully,then remove the wires for the heater switch.
You will find two Phillips screws behind the heater panel you will need to unscrew these and the fascia will release.
You will find two Phillips screws on both sides of the stereo.
You will need to unscrew these and the stereo will release.
Finally you will need to release the wires and the aerial connection to the back of the stereo,the stereo will release and you will have completed removing a stereo.
Congratulations on behalf of the ford centre for succesffully removing a stereo for a fiesta mark 6.
How to refit a mk6 fiesta stereo
firstly you will need to reconnect the stereo wires back into the stereo making sure that all is working before refitting stereo back into the dash.
Write the stereo code on top of the radio for next time and simply push back into the dash.screw the four Phillips screws back into position and check to see if secure.
You will need to get the heater panel back into place with the two phillip screws,connect wires for heater panel,push back into correct position.
Put the surround around the gear stick back into position and screw gear knob back on.
Apply screws back into the little pocket by the steering column and push pocket back into position.
Insert four screws down by the pedals which is holding the plastic surround in position.
Congratulations you have successfully refitted a fiesta stereo.
What else can I help you with?
How do i remove the air filter on a fiesta mk6?
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
What is the hp for a 1.25 fiesta zetec?
the mk6 fiesta 1.25 has 75bhp.
How do you change the oil filter on a Fiesta Mk6?
Depends on the engine. A variety of different petrol engines and a diesel option were fitted to the Fiesta Mk6. All have different filters.
How do you remove fiesta mk6 glove box surrounds?
To remove the glove box surrounds on a Fiesta MK6, first, open the glove box and locate the screws securing the surround. Typically, there are a few screws along the top and sides that need to be removed using a Phillips screwdriver. After removing the screws, gently pry the surround away from the dash, being careful not to damage any clips or connectors. Once loose, you can fully detach the surround from the glove box area.
How do you remove heater matrix on a mk6 fiesta?
To remove the heater matrix from a Mk6 Fiesta, first, disconnect the battery and drain the coolant. Then, remove the dashboard and any necessary components blocking access to the matrix. Disconnect the heater hoses from the matrix, unclip it from the housing, and carefully pull it out. Reassemble in reverse order, ensuring all connections are secure and the system is properly refilled with coolant.
Spark plug gap fiesta mk6 1.4?
Mk6 1.4 Duratec SE 16v 02> gap should be 1.3mm.
How do you remove rear drums on mk6 fiesta?
To remove the rear drum brakes on a Mk6 Fiesta, start by safely lifting the vehicle and securing it on jack stands. Remove the wheel, then locate the drum's retaining screws and remove them if present. Gently tap the drum with a hammer to loosen it, as it may be stuck due to rust or debris. Finally, pull the drum straight off the hub, taking care not to damage the brake components inside.
How do you remove fiesta mk6 steering wheel?
To remove the steering wheel from a Ford Fiesta MK6, first disconnect the battery to ensure safety. Then, use a Torx screwdriver to remove the screws securing the airbag module on the back of the wheel. Carefully disconnect the airbag connector and remove the airbag. Finally, use a socket wrench to unscrew the central nut holding the steering wheel in place, and pull the wheel off the steering column.
How do you remove the rocker box cover on fiesta mk6?
To remove the rocker box cover on a Ford Fiesta MK6, first ensure the engine is cool and disconnect the battery. Then, remove any components obstructing access, such as the air intake or engine cover. Unscrew the bolts securing the rocker cover, gently lift it off, and replace the gasket if necessary before reassembling. Always consult the vehicle's service manual for specific torque specifications and procedures.
How do you remove the air filter on your ford fiesta zetec s Mk6?
To remove the air filter on a Ford Fiesta Zetec S Mk6, first, open the hood and locate the air filter housing. Unscrew the clips or screws securing the housing cover, then carefully lift it off. Remove the old air filter from the housing and replace it with a new one, ensuring it fits snugly. Finally, reattach the housing cover and secure it with the clips or screws.
Can you fit mk7 rear lights to a mk6 fiesta if so how?
Nope, pins are different.
Where are the speakers in a Ford Fiesta mk6?
in the door panel and in the the rear side panels. hope this helps
