Begin by removing the dashboard speaker covers on your 1989 Chevy S 10 Blazer. Remove the speaker retaining screws. Remove the speaker wiring harness. The speakers will come out.
To remove the front speakers from a Chevy Celebrity: 1. Take out the screws from the speaker grills, take the grills out. 2. The speaker is held in with screws, remove them. Lift the speakers out of the dash and unplug the wire harness.
The front speakers in a 1989 Mazda B2600 truck measure 5 inches by 7 inches. These speakers are located in the front doors.
you dont, if you want to disconnect it then remove your front drive shaft.
To install front dash speakers in a 1989 Mercury Grand Marquis, first, remove the dashboard cover by unscrewing any fasteners and gently prying it off. Next, disconnect the old speakers and remove them from their mounts. Install the new speakers by connecting the wiring harness and securing them in place, then reattach the dashboard cover. Finally, test the speakers to ensure they're functioning correctly before putting everything back together.
To access the front speakers in a 1989 Oldsmobile Cutlass Ciera, first, remove the door panels by unscrewing any visible screws and gently prying off the panel to detach it from the clips. Once the panel is off, you’ll see the speaker mounted in the door. Disconnect the wiring harness from the speaker, and then unscrew it from its bracket to remove it. Reassemble in reverse order after replacing or inspecting the speakers.
i have a 1989 chevy blazer gos in 4x4 drive but front wheels are not pulling wat do i do about that
To remove the tailgate lock on a 1989 S-10 Blazer, first remove the cover over the inside of the tailgate by removing the bolts on the side and on the handle. Pop the vinyl away from the tailgate. Then remove the bolts holding the lock on and remove the lock.
to the best of my knowledge:5"
yes, 82-93 are the same besides grill design
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
5 1/4 front and rear
Next to the water neck on the front of the intake manifold.