You cannot remove the moisture for the long term as the sealed beam seal has failed and moisture will continue to appear later.
Usually a heat gun could be used to heat up the glass, careful not to melt any nearby plastic parts.
Best bet is to replace the headlight.
Throw rice on it about 2 gallons 5 times
You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.
If its like a 99, you have to remove the entire front bumper. That's what I had to do on mine. It was a total pain! Good luck!
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
Moisture can accumulate in any headlight, most likely the cause is a bad seal between the two pieces of the fixture.
How to remove headlight assembly on 2003 Lexus GX470
# Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now # Disconnect negative battery cable # Remove the retaining screws and detach the headlight bezel # Remove the headlight retainer screws taking care not to disturb the adjusting screws # Remove the retainer and pull the headlight out enough to allow the connector to be unplugged # Remove headlight now
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
How do you remove the headlight assembly on a 2001 camaro?"
You must remove the front bumper to access the headlight.
Remove the retaining screws from the headlight assembly. Remove the wiring harness from the back of the headlight. The headlight will come out. Reverse the process to install the new headlight.
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.