If the drum is jammed on, get a short piece of 2x4 about 6-8 inches and a small heavy hammer. Fit block on back of drum and pound once, rotate to opposite side and do again. keep doing this,it will come off.
what would cause F250 2002 Ford to hold back like ememergy brake on
ask a engineer
how to remove rear axle from 1988 f250 ford
Lift the vehicle with a jack, remove the tire, remove the caliper/brake shoe, remove the old brake pad. Dispose of the old brake pad properly, put in the new brake pad, replace the caliper/brake shoe and replace the tire, then lower the vehicle to the ground.
Remove the tire and wheel. Remove the brake pad Springs. The brake pads and break assembly will come off. Reverse the process to install the new brake pads.
Lift the car, remove the tire, remove the brake shoes/calipers, remove and dispose of the old pads. Put in the new pads, replace the brake shoe/caliper, replace the tire and lower the car.
a 1997 f250 has 250 hp
Remove master cylinder-hopefully there is enough room not to have to disconnect brake lines Remove Brake pedal linkage at brake pedal Remove vacuum line Unbolt and twist vacuum booster to remove
15- 20mpg
how do you remove the radio from an 06 f250
a T-50 star bit is needed to remove the bolt
In the tank(s)