To remove the rear bumper from a Mk6 Fiesta, start by opening the trunk and removing any screws or clips securing the bumper to the body. Next, detach the rear light assemblies by unscrewing them and disconnecting the wiring harness. Then, gently pull the bumper away from the car, taking care to release any additional clips or fasteners along the sides and at the bottom. Finally, ensure all connections are unclipped before fully removing the bumper from the vehicle.
To remove the air filter on the Fiesta MK6, first remove the bolts on the top of the air filter box. Then, pull upward to remove the rubber gasket around the box. Remove the screws at the rear of the box. Remove the filter and replace it.?æ
Nope, pins are different.
To remove the rear drum brakes on a Mk6 Fiesta, start by safely lifting the vehicle and securing it on jack stands. Remove the wheel, then locate the drum's retaining screws and remove them if present. Gently tap the drum with a hammer to loosen it, as it may be stuck due to rust or debris. Finally, pull the drum straight off the hub, taking care not to damage the brake components inside.
in the door panel and in the the rear side panels. hope this helps
The Ford Fiesta rear speakers measure five inches by seven inches. The front speakers measure three inches by five inches.
first you need to take the headlights off. you also need to unclip the wheel arch liner. there are three bolts holding the bumper to the front wing. you need a ratchet socket because its hard to manoeuvre a spanner in the space.once you undo the bolts the bumper will just fall off
the mk6 fiesta 1.25 has 75bhp.
Actually it may be hard to remove rear gearbox mounting from a ford escort mk6. You will need to have a proper guiding manual to follow or use the services of a mechanic.
Depends on the engine. A variety of different petrol engines and a diesel option were fitted to the Fiesta Mk6. All have different filters.
it is behind the lights, accessed from inside the boot, behind the side covers.
To change the rear speakers in a Ford Fiesta MK6, start by removing the rear door trim panels. Use a trim removal tool to gently pry off the clips and screws holding the panel in place. Once the panel is removed, disconnect the old speaker by unscrewing it and unplugging the wiring harness, then replace it with the new speaker. Finally, reattach the door trim panel securely.
Mk6 1.4 Duratec SE 16v 02> gap should be 1.3mm.