those drums are not pressed on. what you need to do is tap it with a hammer and spin it arround tap it in different spots until it comes loose then pull it off with your hands. be careful not to strike the wheel studs. it might take a few minutes to get it off. make sure the emergency brake is released.
It is part of the pump, in the tank.
The 2001-2007 Dodge Caravan and Dodge Grand Caravans have the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
Key on engine off, press gas pedal to the floor three times, cycle key off and back on.
To reset the change oil light on a 2013 Dodge Grand Caravan, first turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal three times within 10 seconds. After doing this, the oil change light should turn off. If it doesn't reset, repeat the process to ensure it was done correctly.
Press lock tab in and then pull.
you press the button it all depends on if your car likes you or not
Push the set button and within 10 seconds press the seek and scan buttons.
If you press the gas pedal down far enough it will downshift into the next lower gear.
You press both buttons once, then the right one once more. The figures will then go to 0000
If you mean the pads, this is relatively simple and similar to most American pad replacements. Remove the caliper, remove pads and then press piston in, fit new pads and re-bolt the caliper. Very simple. Lots of good video on You tube showing this.
u need a press tool like a clamp ask autoz or advance then the fun part holding it together and pressing the ball joint out use some tape after you do 1 its easy
Remove the bolt holding it on, pull it off with a puller and press the new one on,