To remove a sunroof sunshade, first, fully open the sunroof to access the sunshade mechanism. Locate the clips or retaining tabs on either side of the sunshade; gently pull them away from the sunshade to release it. Carefully slide the sunshade out of the tracks, ensuring not to force it, and then lift it out of the sunroof assembly. Always consult your vehicle's manual for specific instructions related to your model.
when you say broken slide, are you talking about the one little plastic slide that in installed in the sunroof cassete , or the slides installed on the sunshade it self, it its the shade your talking about, remove the sunroof glass with the 6 t25 torx bolts holding it in, 3 on each side, remove the glass, now slide the sunshade forwared and from the top inspect the sunshade, if it is faulty, or any guides on the shade it self are bad, then remove the t10 torx screws holding the sunshade in and replace them, however if its the small plastic peace that actually move the sunshade when opening and closing the sunroof, then you will need to replace that also, that is complicated and should be taken to a dealer. hope this helps.
Remove the sunshade from the sunshade anchor. Rotate the sunshade parallel to the door and pull in a downward motion in order to disconnect the sunshade retention clip. Remove the sunshade from the sunshade bezel. Disconnect the electrical connector if required. Remove the sunshade bezel from the headliner if required. Install the sunshade bezel to the headliner if required. Connect the electrical connector if required. Align the sunshade parallel to the door. Install the sunshade to the sunshade bezel. Push up on the sunshade and rotate the sunshade toward the front glass in order to connect the retention clip. Reattach the sunshade to the sunshade anchor.
use the sunroof tool in your spare tire tool pouch to manually close.
To remove the moon roof sunshade in a 1997 Ford Explorer, first, slide the sunshade all the way back to its open position. Next, locate the clips or retaining clips that hold the sunshade in place, typically found along the edges. Carefully unclip or unscrew these fasteners, and then gently pull the sunshade down and out of its track. Be cautious to avoid damaging any surrounding components during the removal process.
The headliner must be removed in order to gain access to the sunhade. Ii have diagrams for the removal of the sunshade with specific instructions . Please provide me me with your name and address, I can make copies of the shop manual pages and mail them to you. jb
THESE DIRECTIONS COME DIRECTLY FROM GM 1. REMOVE THE WINDSHEILD GARNISH MOLDING. 2. RELEASE THE FRONT ASSIST HANDLE FROM THE HEADLINER.(TO DO THIS YOU MUST POP OFF THE COVER ON EITHER SIDE AND YOU WILL SEE A RETAINER CLIP ON THE OUTER EDGES OF EITHER SIDE. INSERT A SMALL PICK OR FLAT HEAD SCREW DRIVER AND PRESS THE CLIP TOWARDS THE INSIDE OF THE HANDLE. THEN PRESS THE END OF THE HANDLE OUTWARD AND PULL IT SHOULD RELEASE.) 3. RELEASE THE UPPER PORTION OF THE CENTER PILLAR TRIM PANEL. 4. OPEN AND ROTATE THE SUNSHADE PARALLEL TO THE SIDE WINDOW. 5. INSERT A SMALL TOOL INTO THE BEZEL ACCESS HOLE. 6 PUSH UPWARD ON THE TOOL WHILE ROTATING THE SUNSHADE PARALLELL TO THE WINDSHEILD. THE SUNSHADE PIVOT ARM BEZEL SHOULD APPEAR TO BE RECESSED INTO THE BEZEL. 7. APPLY OUTBOARD PRESSURE TO THE SUNSHADE WHILE THE SUNSHADE IS PARALLEL TO THE WINDSHEILD. 8. PULL THE SUNSHADE DOWNARD WHILE MAINTAINING OUTBOARD PRESSURE TO THE SUNSHADE. YOU WILL NOTICE A SEPARATION BETWEEN THE HEADLINER AND THE SUNSHADE BEZEL. 9. IN ORDER TO REMOVE THE SUNSHADE FROM THE HEADLINER, CAREFULLY GRAB THE HEADLINER AT THE WINDSHEILD PILLAR AREA AND APPLY DOWNARD PRESSURE WHILE GENTLY ROCKING THE SUNSHADE UP AND DOWN. 10. REMOVE THE INBOARD RETAINER SCREW. 11. REMOVE THE INBOARD RETAINER FROM THE HEADLINER. 12. IF THE VEHICLE IS EQUIPPED WITH LIGHTED SUNSHADES REMOVE THE ELECTRICAL CONNECTORS FROM THE HEADLINER.
To lower a stuck rear sunshade in a 2006 CL 55 AMG, you may need to access the sunshade motor and manually turn it to release the sunshade. First, remove the rear parcel shelf to access the motor mechanism. Next, locate the motor and use a tool to manually turn it in the direction that would lower the sunshade. Be cautious while performing this task to avoid damaging any components.
how to remove a sunroof in a 1998 Saturn 4 door sedan
Sunday sunshine sunlight sunhat suntan sunburn sunglasses sundial sundress sundeck sunbelt sunscreen sunflower sundown sunup sunburst sunbonnet sunbathe sunlamp sunrise sunroof sunshade sunroof sunset sunspot sunstroke
first of all close the sunroof fully, then pull down the trim cover (held on by pop type clips). Then you will see 4 10mm nuts, 1 in each corner. Remove them and then carefully lift up the sunroof to remove.
slide headlinercover back, raise sunroof, unsnapp liner, open sunroof fully, pull the sunroof liner/cover out and tint the the glass or refinish the headlinersunroof cover
To remove the sunroof on a 1993 Isuzu Amigo, first, ensure the vehicle is parked safely and the ignition is off. Begin by removing the sunroof trim by carefully prying it off with a flat tool, then unscrew the mounting screws located around the sunroof frame. Once the screws are removed, gently lift the sunroof out of the frame, taking care not to damage the surrounding area. It may be helpful to have a second person assist with holding the sunroof while you detach it.