answersLogoWhite

0

Remove the cables from the 2001 Monte Carlo, then take out the battery hold down. Lift the battery out and put the new one in. Install the hold down, then connect the cables back.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How to remove engine 2001 Monte Carlo?

how to remove the engine of the 2001 monte carlo step by step


Where is the ecm located on a 2001 Chevy Monte Carlo?

Underneath the battery, underneath the battery tray.


How do you remove door seal on 2001 Monte Carlo?

pull hard


How do you change radiator in Monte Carlo ss 2001?

how to change a radiator in 2001 Monte Carlo


What happens if you unplug your battery and still doesn't start 2001 Monte Carlo?

If you unplug the battery is for sure is not going to start. What are you asking?


What are the ratings and certificates for Monte Carlo - 2001?

Monte Carlo - 2001 is rated/received certificates of: Australia:M Netherlands:12


How do you change idler pulley on 2001 Monte Carlo?

You can change an idler pulley on a 2001 Monte Carlo by first, removing the negative cable from the battery. Using a socket wrench, loosen the tension adjustment bolt. Slide the serpentine belt away from the pulley. Remove?æthe center bolt, and remove the pulley from the engine. Replace the pulley,?æreturn and tighten the bolts, and replace the serpentine belt.


How do you change ignition cylinder on 2001 Monte Carlo?

how do i change a ignition cylinder on a 01 Monte Carlo


How many oxygen sensors is on on a 2001 Monte Carlo ss and what is bank 2?

There are 2 oxygen sensors on a 2001 SS Monte Carlo.


How do you remove bezel on 2001 Monte Carlo?

How do I replace the flasher and fues for the turn singals and hazzard warning lights.


Where is the Body Control Module located on a 2001 Chevy Monte Carlo?

were is the bcm located on a 2000 monte carlo


How do you remove the power steering pump on a 2001 Monte Carlo?

Start by removing the lines, drain the fluids, then remove the pump pulley. After that, remove the mounting bolts.