0
HI, The first question I need to know is, have you removed the fan yet? And why do you want to remove the clutch? Are you trying to replace the fan/clutch assy? If you have not removed the fan/clutch then here's how to get that out. First drain the cooling system so the coolant is below the upper radiator hose. Take the upper hose off of the radiator. remove all of the fan shroud retaining fasteners. Loosen all of the fan/clutch mounting fasteners. remove the water pump drive belt. Remove the fan/clutch mounting fasteners, then lift the fan/clutch and fan shroud out together. Then remove the clutch however you can. Reverse what you did to replace everything and replace the coolant. This could be a good time to replace all your coolant if it hasn't been done for as while. Good luck and if you need more help, we hope you'll clarify your question. Steve H.
What else can I help you with?
Were is the clutch reservoir for the 1995 Geo Tracker?
All 1995 GEO Trackers have a clutch cable that is adjustable instead of a clutch reservior filled with hydraulic fluid.
I have 1995 4x4 Geo Tracker with a bad auto transmission will auto transmission out of 1998 4x4 Geo Tracker fit in 1995 Geo Tracker?
i have 1995 4x4 geo tracker with a bad auto transmission will a auto transmission out 1998 4x4 geo tracker fit in 1995
Where is the clutch reservoir in a Geo Tracker?
it has a cable. will not have a clutch reservoir
Where is the clutch reservoir on 1996 Geo Tracker?
The clutch reservoir on a 1996 Geo Tracker is located in the engine compartment, near the firewall. It stores clutch fluid which is pulled into the system as needed.
Will a fivespeed trans out of a 1990 Geo Tracker fit a 1995 Geo Tracker?
Yes it should.
How do you change the clutch cable on a 96 Geo Tracker?
hjfdjdfjgjdf
How do you adjust the clutch pedal on a 1995 Geo Prizm?
how much cost to change a clutch for a geo prizm 1995
Where is the clutch sensor on a 1996 Geo Tracker?
on the firewall under the clutch pedal, It is actually a switch
Why wont Geo Tracker clutch disengage?
torque flight transmission
How do you get sterio out of a 1995 Geo Tracker?
get a bigger hammer
Where is the slave cylinder in a 95 Geo Tracker?
In a 1995 Geo Tracker, the slave cylinder is located on the driver's side of the vehicle, mounted on the transmission. It is positioned near the bell housing and attached to the clutch fork. To access it, you may need to remove the transmission or certain components for better visibility and reach. Make sure to consult a repair manual for specific instructions and diagrams.
Will a 88-94 Geo Tracker Soft top fit a 1995 Model?
yes a,90-99,willfit a geo tracker.
