answersLogoWhite

0

These jeeps have a metal plate, and then a rubber bumper cover is bolted onto the plate. There are two bolts on either side of the bumper cover (on the inside of the bumper cover). Taking the cover off requires a ratchet. Taking the plate off requires a bit more work, as there are more bolts to contend with, as well as the skid plate, etc.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you change the low beam bulb on 2008 passat wagon?

I think you have to remove the front bumper to get full control to the bulb.


How do you remove a 1998 ford expedition front bumper?

http://ww2.justanswer.com/uploads/cheeko12/2008-08-18_195927_eb1.pdf


How DO you remove the front bumper on a 2008 vectra estate?

To remove the front bumper on a 2008 Vectra estate, start by ensuring the vehicle is parked on a flat surface and the ignition is off. Remove any screws or bolts located in the wheel arches and underneath the bumper, typically found in the lower grille area. After that, gently pull out the clips or fasteners along the top edge of the bumper, then carefully detach the bumper from the vehicle, ensuring to disconnect any wiring for lights if applicable. Always refer to the vehicle's manual for specific instructions and torque specifications.


What is the bumper to bumper length of 2008 jeep unlimited 4 dr and 2008 ford escape 4dr?

Easy to find out. Drive down to you local Jeep & Ford dealer with a tape measure in hand and measure them.


How do you replace a headlight assy on a 2008 Subaru Outback?

Not an easy task since you have to remove the Front Bumper Cover to get access to it. Once that's done, remove the electrical connectors, the screws and the Headlight Assembly.


What are the release dates for Bumper to Bumper - 2008 SUSPENDED?

Bumper to Bumper - 2008 SUSPENDED was released on: USA: 2008


How do you remove front license plate bracket 2009 Mercury Mariner?

It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.


How do you remove a front bumper from a 2008 express van?

remove marker lights take out 4 bolts to grill popout and remove end bolts on bummper first than 2 down tru frame horn takes about 30 minutesh


Where is the radiator in a 2008 BMW 535i?

In a 2008 BMW 535i, the radiator is located at the front of the engine bay, behind the front grille and in front of the engine. It is positioned between the engine and the front bumper, allowing for optimal airflow to facilitate cooling. Accessing the radiator typically requires removing the front bumper or various components for maintenance or replacement.


Will front bumper off silverado 2008 fit on a 1997 1500 12 ton silverado?

no


2008 rear bumper Chrysler Sebring how to take it off?

To remove the rear bumper from a 2008 Chrysler Sebring, start by disconnecting the negative battery cable for safety. Then, remove any screws or bolts securing the bumper, which are typically located under the rear lights and along the underside of the bumper. Carefully detach the clips or fasteners holding the bumper in place, and gently pull the bumper away from the vehicle. Finally, disconnect any electrical connectors for rear lights if applicable before fully removing the bumper.


Where is the outside air temperature sensor on a 2008 Mazda 3?

It is attached to the lower grill on the front bumper.