Under the hood on the drivers side is the engine wiring harness. Disconnect bolt from the center it has 1/4" head. Pull out both connectors together. Under the dash on the drivers side the fuse box has two screws , top left and lower right, which hold box to firewall.
It is a 10 amp fuse, upper right area in the fuse box under the dash.
The fuse and relay for the fuel pump are located in the engine. The pump itself is located in the gas tank.
In a 1988 Jeep Comanche, the fuse box is typically located under the dashboard on the driver's side. You may need to remove a cover to access it. The fuse box contains various fuses for different electrical systems, and a diagram on the cover or in the owner's manual can help identify which fuse corresponds to specific functions. Always ensure the vehicle is off before inspecting or replacing fuses.
get a bigger fuse or just branch a peice of wire were the fuse for the blinker goes
On my 87 Comanche, Interior of the Cab drivers side fuse box long silver circuit breaker at the bottom of the fuse box. By long I mean rectangular as opposed to round. It is a circuit breaker not a fuse that controls the Wipers.
On a 1989 Jeep Comanche pickup, the horn fuse is located in the fuse box under the dashboard on the driver's side. You can access it by removing the cover of the fuse box, which is typically found near the steering column. The specific fuse for the horn is usually labeled in the diagram on the fuse box cover. If the horn isn't working, check this fuse first to see if it needs replacing.
Answer flasher on 89 ComancheIf you are referring to the blinker "flasher fuse", it is the bottom round fuse under the dash in the fuse block.
its under the dash on the driver side
Under the dash to left of the steering column.
To remove a fuse from the fuse box in a 2004 Jeep Wrangler, first, locate the fuse box, which is typically found under the dashboard on the driver's side or in the engine compartment. Use a fuse puller or a pair of needle-nose pliers to grasp the fuse you want to remove. Pull the fuse straight out of its slot. Ensure the vehicle is turned off before doing this for safety.
check the fuse or the ground on the heater
If your Jeep Comanche headlights won't turn on, it could be due to a blown fuse, a faulty headlight switch, or a problem with the wiring or connections. Start by checking the fuse box for any blown fuses related to the headlights. If the fuses are intact, inspect the headlight bulbs and wiring for any signs of damage or corrosion. If everything appears normal, it may be necessary to consult a mechanic for a more in-depth diagnosis.