* Disable the airbag system * Remove the instrument cluster bezel * Remove the retaining screws and pull the cluster forward * Unplug the electrical connectors and remove the cluster from the car
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
To remove the bezel instrument cover in a 2004 Suzuki Forenza, start by carefully prying off the trim surrounding the instrument cluster using a flathead screwdriver or a trim removal tool. Once the trim is removed, unscrew any fasteners holding the instrument cluster in place. Gently pull the instrument cluster forward to access the wiring connectors, which you can disconnect. Finally, lift the bezel instrument cover off to complete the removal.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
To remove the instrument cluster on a 1987 El Camino, first disconnect the negative battery cable to ensure safety. Then, remove the screws or bolts securing the trim bezel around the cluster, and gently pull the bezel away. Next, unscrew the mounting screws for the instrument cluster itself, disconnect any electrical connectors, and carefully pull the cluster out of the dashboard. Be sure to handle it gently to avoid damaging any components.
Remove the two screws at the top of the instrument cluster. This will allow you to pull out the entire bezel. Pull out the bezel, and pop the switch out from the bezel.
Nevermind. I found the solution through another question.
# Disconnect the negative battery cable. # Apply the parking brake and block the rear wheels. # Turn the ignition switch to the OFF position. # Shift the gearshift lever to the 1position. # Position the steering wheel in the full-down position. # Remove the two instrument cluster bezel screws. # Separate the instrument cluster bezel from the instrument panel enough to gain access to the electrical connectors. Disconnect the following electrical connectors: # Rear window wiper/washer switch # Rear window defogger switch # Hazard warning flasher switch # Power E-AT switch, if equipped # Security indicator lamp, if equipped # Cruise control ON/OFF switch # Headlamp switch # Remove the instrument cluster bezel with the switches attached. # Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel. # Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster. # Disconnect the electrical connectors from the instrument cluster and remove the cluster. # The installation is the reverse of removal.
To remove the instrument cluster from a 1997 Geo Tracker, first disconnect the negative battery terminal to prevent electrical issues. Next, remove the screws securing the cluster trim bezel and carefully pry it away. Then, unscrew the instrument cluster itself, disconnect the electrical connectors at the back, and gently pull the cluster out. Reverse the process to install the new cluster.
1. disconnect negative battery cable and wait 2 minutes (this disarms the airbag circuit while you work in that area). Remove the left end cover by pulling outward. Tilt steering column down to lowest position. remove instrument cluster center bezel (around radio and environmental controls) by disengaging 4 clips (2 on top and one on each side). 2. Remove 4 instrument cluster hood mounting screws. Three screws are located behind the center bezel and one screw is located at the left end of the hood. Pull on hood to disengage hood and remove instrument cluster hood. Pull instrument cluster rearward to disengage 8 clips and disconnect wiring connectors from panel. Remove instrument cluster.
Remove the 2 screws at the top of the instrument cluster bezel (or dress front cover), carefully pry out with a small screwdriver and set aside. Remove the 4 screws that hold the instrument cluster to the inner dash and pull out. Turn instrument cluster over to access the bulbs for removal and replacement. Twist the bulb retainer to remove.
What kind of car?? 1999 grand am