pull frame from around radio four screw located around radio open glovebox reach behind unplug power and radio ant pullout
crowbar
This may not apply to your model but, some Later models of the Geo provided access to the radio through the glove box. The bracket in these models can be accessed from the glove box and then the radio can be pushed out of the dash board.new answer headlineThere were no 98 Geo Metro's, only Chevy metro's. They require a special tool to release holding pins.
you have to remove the head first.....
Check for a blown fuse.
To wire a radio in a 1994 Geo Metro, start by disconnecting the car battery to ensure safety. Remove the dashboard panels to access the radio, then disconnect the old radio's wiring harness and antenna. Connect the new radio's wiring harness to the car's harness, matching the colors (typically red for power, black for ground, etc.), and connect the antenna. Finally, secure the radio in place, reassemble the dashboard, and reconnect the battery to test the new radio.
Can you swap a 93 Geo metro manual transmition with a 95 Geo Metro
Unfortunately, you have to remove the transmission.
What one of the 16 trim panels I can think of on the Metro And what year, Because it matters!
General Motors A Geo Metro is a Cheverolet geo and Chevy metro are both made by suzuki in Canada
The geo metro is by far is the best v8 car.
Remove the center bezel and the glove box. Take out the four screws holding it in and then reach through the glove box opening and remove the mounting bracket screw then push the radio forward and unplug the connector and antenna. That's it.
yes