0
What else can I help you with?
How do you remove male pipe threads that broke off in a female pipe?
With a extractor
The shower arm broke off at the threads and now the threading is stuck in the other pipe how do you remove old threading to replace the arm?
Easy-Outs and Internal Pipe Wrenches seldom work--they are not sized closely enough to what you need to remove the thin-wall pipe of the broken arm. But this method really works: Take a #10 (10") tapered flat file and hammer it into the broken thread section. The grooves in the file should grip the broken piece, and you can use pliers to turn the file and unthread the broken piece. You may need to hammer it in pretty hard so the file gets an adequate grip.
How do you remove male pipe threads that broke off in a?
Depends. What it is broke off in. Sometimes you can use a hacksaw blade and cut through the male part just through the threads and then pry out the piece. I have sometimes had to make three cuts and take the pipe out in sections. If it is in another pipe and you can heat the end, this will loosen the pipe and an E Z out or extractor can be used to back out the piece. If it is a small pipe that is too small for a hacksaw blade, if you are very careful and lucky, you can drill out most of the pipe to the threads in the female part and then peal out the thread or rethread the female side which will clean out the threads.
How do you remove toilet flange from pipe?
To remove a toilet flange from a pipe, first turn off the water supply and disconnect the toilet from the flange. Use a utility knife to cut any caulk or adhesive around the flange. If the flange is secured with screws, use a screwdriver to remove them. Finally, gently lift the flange off the pipe, taking care not to damage the pipe itself.
How can I remove an outdoor faucet?
To remove an outdoor faucet, first turn off the water supply to the faucet. Then, use a wrench to loosen and remove the nut connecting the faucet to the water pipe. Finally, carefully pull the faucet out of the pipe.
How do you turn off hyper-threading?
There should be a setting in the BIOS to enable or disable Hyper-Threading (HT), the change can be made there.
How can I remove a shower arm?
To remove a shower arm, you will need to use a pipe wrench or adjustable wrench to unscrew it counterclockwise from the water supply pipe in the wall. Be sure to turn off the water supply before attempting to remove the shower arm.
How can I remove a PVC pipe fitting after it has been glued?
To remove a PVC pipe fitting that has been glued, you can use a heat gun to soften the adhesive and then twist and pull the fitting off. Be sure to wear protective gear and work carefully to avoid damaging the pipe.
What tool do you need to remove a cemented on cap off of a drain pipe?
Cut the end of the cap off, about 1/2 inch back from the end and then cut the side of the cap. You should be able to peel the cap off of the pipe. If you have enough pipe, just cut the entire cap off and start with a clean section.
How do you turn off Hyper-Threading technology?
There should be a setting in the BIOS to enable or disable Hyper-Threading (HT), the change can be made there.
How can I remove a PVC pipe effectively and safely?
To remove a PVC pipe effectively and safely, first turn off the water supply and release any pressure in the pipe. Use a hacksaw or PVC pipe cutter to cut the pipe cleanly. Wear gloves and eye protection to prevent injury from sharp edges. Sand the cut edges smooth and use a coupling or fitting to reconnect the pipe if needed.
How can i remove the key which broke off in the ignition in a 1992 Chevy Lumina Z34?
Gum maybe?? or tweaser??
