answersLogoWhite

0

usually your intake manifold is ok...the manifold gaskets are prone to failure..they are plastic with rubber impregnated seals...if the manifold is actually pitted, you can repair with JB WELD then sand smooth....

ase master certified tech

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace intake manifold gaskets 1997 z34 Monte Carlo?

i suggest you get a repair book.it is not easy


Where is the oil sending unit located on 1997 Chevy s10 blazer 4.3 v6?

It is on the firewall end of the intake manifold below the distributor


Where is the Fuel Pressure Regulator on a 1997 Chevy Blazer V6?

It is attached to the bank of fuel injectors (the spider) under the upper intake manifold.


Where is the fuel pressure regulator located on a 1997 Chevy blazer?

Assuming this is a 4.3L engine, the fuel pressure regulator is located under the upper intake manifold. The upper intake manifold must be removed to gain access to the regulator.


Where is MAP sensor in 1997 Blazer?

Oh, the MAP sensor in your 1997 Blazer is usually located on the intake manifold or firewall. It's a small, important part that helps your engine run smoothly by measuring the air pressure in the intake system. Just take your time and follow the hoses from the intake manifold to locate it, and remember, there are no mistakes, just happy little accidents in the world of car maintenance.


Where is the fuel pressure regulator located on a 1997 Chevrolet s-10 blazer?

Assuming you have the 4.3L engine it would be located under the upper intake manifold. After removing the upper intake manifold you will see the fuel pressure regulator attached to the bank of injector "poppets".


Where is the intake on a 1997 GMC Yukon?

intake manifold is under the throttle body


What are the intake manifold torque specs on 1997 Oldsmobile bravada?

What are the intake manifold torque specs on 1998 Oldsmobile bravada?"


How do you replace the intake manifold gasket 1997 blazer?

http://d-tips.com/General/Articles/article.aspx?id=/free/How%20to/GM%204.3L%20Intake%20Manifold%20repair/43intakearticle.art


Where is the thermostat located on a 1997 Chevy Blazer?

located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.


Where is the intake manifold on a 1997 mercury villager?

The Villager has an upper and lower intake manifold. It is at the top of the engine with the throttle body attached to it.


How much does intake manifold cost for a 1997?

$0 recall