To replace the CV joint on a 2002 Chevy, first, safely lift the vehicle and remove the wheel. Next, detach the axle nut and the lower control arm to free the axle from the hub assembly. Remove the old CV joint from the axle shaft and replace it with a new one, ensuring to properly grease it and secure it with a clamp. Finally, reassemble the components in reverse order, making sure to torque all fasteners to the manufacturer's specifications.
how do you replace a CV joint on a 1992 Chevy pickup?
It will cost approximately $225 to replace a CV joint in your Chevrolet Avalanche. The CV joint will cost approximately $80 and require two hours of labor.
A chevy 3500 truck is not front wheel drive, so it does not have CV joints.
The boot on my cv joint is stuck inside of the trans how do u go about getting that out and what else do i need to fix after that comes out
To replace the CV joint on a 2004 Chevy Aveo, start by safely lifting the vehicle and removing the wheel. Then, detach the axle nut and any necessary components, such as the brake caliper and rotor, to access the CV joint. Remove the old CV joint from the axle shaft, clean the area, and install the new CV joint, ensuring proper alignment. Finally, reassemble all parts, torque the axle nut to specifications, and lower the vehicle.
If you replace the entire cv joint axle in MD you will have $82 in the new axle + labor in a garage $40-$60 per hr. I did it myself. not a bad job.
how do you replace the drivers side drive shaft and cv joint?
don't replace the joint. replace the axle
Replace the complete halfshaft assembly, it is much easier than trying to replace the cv joint itself.
The CV joint in a 2000 Kia Sportage can be replace by roving the tires, axle nuts, and the knuckle bolts on the struts. Next, the CV joint can be removed by placing a screwdriver between the transmission and the CV joint will pop out.
How much does it cost to replace a cv joint on 4 wheel drive
To replace a CV joint on a 2010 Chevy Cobalt, start by safely lifting the vehicle and removing the wheel. Disconnect the suspension components, such as the tie rod and lower control arm, to access the axle. Remove the axle nut, then pull the axle out of the hub and remove it from the transmission. Finally, install the new CV joint by reversing the disassembly steps, ensuring everything is properly torqued and reassembled.