Here is what the owner's manual says for our 2008 Chevy HHR says about replacing headlamps. It is a copy-and-paste job from a pdf file.
To replace the headlamp, turn signal, or parking
lamp bulb:
1. Turn the wheel to access the wheel well.
2. Remove the fasteners to access the headlamp and
the turn signal/parking lamp bulbs.
3. Reach in behind the wheel well liner and locate the
bulb to be changed.
4. Turn the bulb socket counterclockwise to remove.
5. Pull the old bulb out of the socket.
6. Install a new bulb.
7. Reverse Steps 1 through 4 to reinstall.
The manual had a diagram that would not copy. It showed three locations where the fasteners are located on the edge of the wheel well in front of the wheel itself. I top fastener was a small hex-head screw. The bottom two were round capped plastic plugs. They did not come out by me pulling on them and prying with a screw driver. I didn't want to mess anything up, so I went online for help.
yes you do
trouble putting right front signal bulb in.
underneith the front bumber twist counter clockwise replace bulb
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
How do you replace the front turn signal bulb located on a 2001 Buick Century?"
rear you use a torx driver to remove taillight assembly screws. them replace bulb.
HOW TO REPLACE FRONT TURN SIGNAL BULB 2007 EQUINOX
pictures of how to change front signal bulbs on a 2004 grand prix pontiac
Hey Rick==Simply get to the back of the light assy and turn the bulb counterclockwise to remove. GoodluckJoe
howtochange the dashboard blubs
To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.
If you are talking about a front turn signal, there is a release tab inside the fender. when you push it it will release the whole light assembly. Then you can access the bulb