answersLogoWhite

0

To replace a headlamp bulb on a 2007 Nissan Murano, first, turn off the vehicle and open the hood. Locate the back of the headlamp assembly, then remove the electrical connector by pulling it straight off. Twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one, taking care not to touch the glass. Reinsert the bulb socket, reconnect the electrical connector, and test the headlamp before closing the hood.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Trending Questions
How do you reset the maintenance required light on a 2011 Toyota Corolla? Where is the horn on a Freelander 2? Can an 07 tdci fiesta run on bio diesel? How do you overhaul a Halibrand quick change? Where is the crank sensor on 2004 Hyundai tiburon 2.7 located? Where is external fuel filter for the 2001 Dodge Durango? What is the firing order for a 1998 GMC pickup with a 5.7L vortec? How do you get a 2.3 ford back in time after replacing the distributor and belt crankshaft and camshaft are lined up with there correct settings but there is something that is missing but cant find it? The dinger for the door ajar - does it have a fuss - which one is it can't find OM? Why does my Mazda 3 car alarm goes off for no reason? 97 Buick sometimes it smells like rubber or something burning when the heater is running antifreeze is low at times is this a intake problem? Where are g-shocks made? What could cause a watery sound behind the dash when you make a turn in a 2004 impala? Change headlight bulbs Ford F-150 year 2000? How many miles will 1998 Ford Explorer 4.0 V6 SOHC timing chains that were replaced at 60k mi in 2004 per recall last after they start making a rattle noise at idle rpm and mostly when engine is cold? How do you change the speedometer cable on a 1990 Chrysler New Yorker? Where is the fork compression adjustment on 99 YZ 400? Can you use John Deere waterless antifreeze in your classic car? How do I change the transmission fluid for a 2000 Chevy Prizm? Does the timing plate need to come off when chaning the intake gacket?