On a Lift from below.
I cut the back of my hands removing an almost new pump from the green machine after I totaled it.
My mechanic put it in by droping the tank. The hoses are the worst part. I cut them on the salvaged part.
MoreIn theory you can replace it through the access plate in the trunk. That's how I remover the one in the green machine. It is real hard to disconnect and reconnect the hoses from above. Putting the car on jack stands and crawing under doesn't help much. With small hands and long arms it may be possible.On 940 without the Regina pump there are two pumps one a low volume pump in the tank attached to the fuel sender monster and the other is under the driver's side of the car mounted with a fule filter on a removable plate.
The pump in the tank can be removed by popping he plate in the trunk and disconnecting the hoses and wires for the pump and sender unit. It needs to be twisted out because 1. the access plate is too small and 2. the design is unnecessarily complex. Replacement is much more difficult because the sender, tank filler assembly can come apart and drop into the tank making it necessary to start over. This is a bad design all around.
The under car pump can be removed easily by disconnection the fuel feed line and clamping it to prevent siphoning, unbolting the fuel filter banjo fitting that runs to the fuel rail on the engine, and removing the two bolts and one nut that hold the bracket to the frame. The electrical connectors are push on pull off type. The pump is a proprietary design and it can be a pain to modify an after market pump to match up to the banjo, fuel input and electrical connectors all of which are proprietary. This is another bad design.
Most problems can be solved by checking the fuel pump relay before you start.
To remove and replace the ignition switch electric part on a 1992 Volvo 940 sedan, first disconnect the battery to ensure safety. Then, remove the plastic cover surrounding the steering column and locate the ignition switch. Disconnect the wiring harness from the ignition switch, unbolt it from its position, and replace it with the new switch. Finally, reassemble the steering column cover and reconnect the battery.
To replace the alternator belt on a 1992 Volvo 940 GL sedan, first, disconnect the negative battery terminal to ensure safety. Loosen the alternator mounting bolts and the tensioner bolt to relieve tension on the old belt. Remove the old belt and install the new one, ensuring it's properly aligned on the pulleys. Finally, adjust the tension by repositioning the alternator, tighten the bolts, and reconnect the battery terminal.
with copper wire
You don't. When it gets dirty, you replace it.
The cast of Regina - 1992 includes: Juanita Dias Broughton as Girl at florist
where does the camshaft sensor go in a 1992 Cadillac Sedan Deville?
You need to replace it. There are 2 screws that hold it on.
Which one, the middle one or one of the two outside ones and is it the whole lamp or just the bulb you want to replace?
Volvo Olympian was created in 1992.
1330kg
Remove the front bumper cover. The tank and pump should be free for removal from the bottom.
The 1992-1995 Honda Civic LX Sedan has a 102 horsepower 16 valve engine called the D1587.