How do you replace a headlight bulb on a 2006 Chrysler pacifica?

Answer 1

Open the hood. There are two screws (slot head/hex) holding the headlamp module in from the top. Remove these screws. The module is also held in by a clip on the lower side. Once I removed the two screws I was able to wiggle the unit from the bottom and pull it straight out. There is a rubber boot covering access to the back side of the light bulb. Remove the boot and give the headlight lamp a slight turn to the left. I hope your hands are a little smaller than mine... it was a tight fit getting into the back of the module. The lamp fits tight into the socket but pulls straight out. You might need to persuade it with a small flat blade screwdriver. Good Luck