answersLogoWhite

0

hi there,firstly dissconnect your batteries then you go to lhs side off engine if you 60 has a/c you will nedd to undo the 4 bolts that secure the unit and move out of the way .then you will see the .take the top adjustment bolt remove this bolt then underneath the alternator there is a bolt that has a 9/16 nut you willneed two spanners and to be under the car once you get this bolt out dissconnect the electrical plug and if it is diesel the oil lines.allow 30-40 minutesto remove.glen

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the alternator on a 1988 Pontiac fiero?

How do you replace the alternator on a 1988 Pontiac Fiero


How do you replace alternator on a 1988 Toyota pickup?

To replace the alternator on a 1988 Toyota pickup, first disconnect the negative battery cable to ensure safety. Remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting bracket. Disconnect the electrical connections from the alternator, and then install the new alternator by reversing the removal steps, ensuring all bolts and connections are secure before reconnecting the battery. Finally, adjust the drive belt tension as needed.


How much shoud it cost to replace an alternator for your 1988 acura integra LS?

Hou much should it cost to replace an alternator for a 1988 acura integra Ls?


How do you replace the alternator on a 1988 Buick Century?

Disconnect the 1988 Century battery. Remove the alternator battery. Disconnect the alternator wiring, then unbolt the alternator. Bolt in the new alternator, then reverse the procedure to finish the installation.


Where is the voltage regulator on a 1988 Toyota Tercel?

the voltage regulator is built into the alternator


1988 Toyota landcruiser fj wheel alignment spec?

Camber..............1 degree + or - 45min toe........................ 0.04in +or - 0.04in (1+ or - min)


How do you replace the alternator on a 1988 Toyota Tercel?

disconnect negative battery tml.,remove the plug from the alternator,remove the main battery wire from the stud on the alternator, remove the lock bolt, swing alternator down to remove belt, remove pivot bolt, swing alt. until its out. replacement is reverse of remova; To take out the alternator on a 88' tercel, you have to do it from under the car


How do you change alternator for 1988 Toyota pick-up?

the alternator is on the bottom right side of the motor and it is hard to get to without removing the engine but it can be done without removing the whole motor you take the belt off and detach the cables then there are 2 bolts that you take out then you pry it out and replace,


How difficult is it to replace an alternator belt in a 1988 Grand Am and what tools are needed?

What size motor? What accessories do you have? BClear.


How do you replace the alternator on a 1988 Honda CRX?

To remove the alternator on 1988 Honda CRX the negative battery must first be disconnected. The belt needs to be loosen and the mounting bolts need to be removed as well. When unmounted the alternator will slide off, and a new unit can be replaced.


How do you check the alternator on my 1988 Toyota MR2?

To check the alternator on your 1988 Toyota MR2, first ensure the battery is fully charged and the connections are clean and tight. Start the engine and use a multimeter to measure the voltage at the battery terminals; it should read between 13.8 to 14.4 volts if the alternator is functioning properly. If the voltage is lower, the alternator may not be charging the battery effectively. Additionally, listen for any unusual noises from the alternator and check for signs of wear or damage to the belts and connections.


Where is the turn signal relay located and how do you replace it located on a 1988 Toyota Camry?

it is in taylorville