To replace the camshaft position sensor on a 1999 Isuzu Rodeo, first disconnect the negative battery cable for safety. Locate the sensor, typically found near the camshaft on the engine, and unplug its electrical connector. Remove the mounting bolts and carefully take out the old sensor. Install the new sensor by reversing the removal steps, ensuring a secure connection and proper alignment before reconnecting the battery.
It is located between the camshafts right behind the camshaft pulley's.
Not long at all should take no longer then 5 mins
To replace the camshaft position sensor in a 2.2L Isuzu Rodeo, first, disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the front of the engine, and unplug the electrical connector. Remove the mounting bolts securing the sensor and carefully pull it out. Install the new sensor by reversing the removal steps, ensuring the connector is securely connected, and reconnect the battery.
it does not have one, after 2000 modes the camshaft position sensor is eliminated the these vehicles use the use the VRS system to determine where the No. 1 piston is. therefore they only required a Crankshaft sensor not a Camshaft sensor.
PO341 Camshaft Position Sensor Circuit Range Problem
How fixed camshaft sensor circuit low input
On the drivers side head..rear of the head directly behind the intake manifold
please help
the camshaft sensor is at the front of the engine next to the radiator, it is held on with one 10mm bolt and is in the middle of the plastic cambelt cover (this does not need to be removed). unclip wire remove bolt and pull.
It is a Throttle Position Sensor
how do you replace coolant temp sensor on a rodeo
On 97 & earlier it's located on the front left upper corner of the timing belt cover (3.2L). 2.2L it's on top of the front part of the cylinder head between the camshaft sprockets.