first of all, make sure its your clutch. You will have to drop the tranny which will involve removing your front drive train. (both axles) Your clutch will be bolted to the ring gear on your engine, but you cant just change your clutch. You should also change your pressure plate,release bearing, pilot shaft bearing or, in some cases, it might be a bushing buddy its not a small job. I hope this helps good luck
The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.
Buy a Manual. ;)
Buy a Manual. ;)
We need more info here. How do you tell if the clutch has "WHAT" in a Pontiac Sunfire?
you have to remove the tranny and clutch! 4-6 hours depending on who and where you get it done and the tools they have most people charge about $70/$80/hr
Read more: http://wiki.answers.com/How_do_you_replace_the_tail_light_in_a_2000_pontiac_sunfire#ixzz1Nur0XSlq
$1000 - $1500
Take it off
typically about $400.00 it is a modular system rather easy to do.
You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.
It looks as if I'll have to crawl under the front of the car to access the bulb to replace it.
To replace the clutch master cylinder in a 2002 Pontiac Sunfire, start by ensuring the vehicle is safely elevated and secure. Disconnect the negative battery cable, then remove the clutch fluid reservoir cap and drain the fluid. Next, detach the hydraulic lines from the master cylinder, unbolt it from the firewall, and remove it. Install the new master cylinder by reversing the removal steps, ensuring all connections are secure and then refill the hydraulic fluid, bleeding the system to remove any air.