answersLogoWhite

0

To replace a Craftsman starter pulley, first, disconnect the spark plug to ensure safety. Remove the starter assembly by unscrewing it from the engine. Take off the old pulley by detaching any retaining clips or screws, then install the new pulley by reversing the process, ensuring it is securely in place. Finally, reassemble the starter assembly and reconnect the spark plug before testing the starter.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you Replace starter cord on lawn mower?

How do I replace starter cord on lawn mower? Remove the engine starter cover or blower housing which contains the starter rope. Check to see if the spring is still good then just rewind the starter rope pulley to re-tension the spring. Insert the replacement rope into pulley as originally routed and let the spring wind the rope back into pulley. Then replace the starter handle. Make sure you keep tension on the starter pulley while the rope is winding.


How do I replace the Craftsman gas-powered weedwacker starter rope?

go to home depo and buy some


How do you rewind the recoil starter on a craftsman rototiller?

To rewind the recoil starter on a Craftsman rototiller, first, remove the starter cover by unscrewing it. Next, pull the rope out to its full length and then turn the recoil spring clockwise several times to create tension. Once tension is built, insert the rope back into the starter housing, ensuring it's properly aligned in the pulley. Finally, reattach the starter cover and test the recoil by pulling the rope to ensure it retracts smoothly.


Start automatic car without starter motor?

Might try putting an air gun on the crank pulley nut but not recommended. Best to replace the starter motor and do it right


How do you replace an auger cable on craftsman snow blower?

Replace Angus cable craftsman 3.8 snowblower


How do you replace the starter on a craftsman 19.5 horse lawn tractor?

Remove the battery cable on the side of the starter. Then remove the two bolts holding it onto the engine. Once you have your new one just reverse those steps.


Should you replace the brushes on a starter or replace the starter?

replace the starter


How do I line up the right wheel axle and hub to insert a bolt on Craftsman 30 snow blower 536881112?

How do you replace rewind starter on a Sears model #563.884352


How do you replace pull cord on gbi 22v weedeater blower?

To replace the pull cord on a GBI 22V weedeater blower, first, remove the starter cover by unscrewing the screws holding it in place. Take out the old cord from the starter assembly and measure a new cord to the same length, then thread it through the starter pulley and tie a knot to secure it. Wind the new cord around the pulley, then reattach the starter cover and ensure everything is tightened properly before testing the pull cord.


How do you fix the recoil on a craftsman easy start?

To fix the recoil on a Craftsman Easy Start, first ensure the pull cord is not tangled or damaged. If the recoil mechanism is stuck, remove the starter cover and inspect the spring and pulley assembly for any debris or damage; clean or replace as necessary. Rewind the spring properly if it has come loose, and reassemble the components carefully to ensure smooth operation. Lastly, test the recoil by pulling the cord to ensure it retracts properly.


How do you put on tension pulley craftsman?

"Craftsman" is an entire range of tools and equipment and YOU haven't even said what the tool is !How do you expect a reply giving you a proper answer.


What does the starter on a Chevrolet Cobalt look like?

The starter motor is behind the crank pulley on the passenger side. This is not a driveway job. You'll need a lift and a few special tools if you're trying to replace it your self.