0
CRANKSHAFT POSITION SENSOR - 2.5L
REMOVAL
Remove speed control servo from driver's side strut tower.
Remove crankshaft position sensor retaining bolt Crankshaft Position Sensor
Pull crankshaft position sensor straight up out of the transaxle housing.
(Disconnect crankshaft position sensor electrical connector from the wiring harness connector.
INSTALLATION - ADJUSTABLE
All vehicles will be equipped with an adjustable crankshaft position sensor. This can be identified by an elongated mounting hole in the sensor.
NOTE: If the removed sensor is to be reinstalled, clean off the old spacer on the sensor face. A NEW SPACER must be attached to the sensor face before installation. If the sensor is being replaced, confirm that the paper spacer is attached to the face of the new sensor Crankshaft Position Sensor and Spacer
Install sensor in transaxle and push sensor down until contact is made with the drive plate. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque.
Connect crankshaft position sensor electrical connector to the wiring harness connector.
Attach connector to heater tube bracket.
Install speed control servo. Tighten nuts to 9 N·m (80 in. lbs.) torque.
extra steps for
Simplification added by Billebones@AOL.com:
Also: Jack up car and put it on jackstands
Remove left front tire, remove plastic shield covering the battery then use a long extension with a 10mm socket to remove and install the bolt holding the sensor right over the top of the axle, this definitively simplifies getting at the bolt, if you have someone up on top to guide it back in it will be even easier.
I did not remove heater tube bracket and I plugged it together before I put the sensor into the bell housing
What else can I help you with?
What does it cost to replace crankshaft sensor on Chrysler sebring 1999?
60.00 $
Where is the crankshaft sensor on a 2001 sebring 2.7L.?
where is the crankshaft sersor on a 2001 Chrysler sebring located
Why would a 1998 Chrysler Sebring 2.5 v6 not have any spark at plugs?
The Sebring is a Chrysler product. Replace the crankshaft position sensor before beginning any diagnosis.
Where is the crankshaft position sensor on a 2000 Chrysler Sebring 2.5L?
The crankshaft position sensor mounts to the top rear of the transmission bell housing.
Where is the crankshaft sensor on a 1997 Chrysler Sebring with a 2.5?
It is on the top rear of the transmission bell housing.
How do you know if a crankshaft sensor is going bad on a 1996 Chrysler Sebring convertible?
When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.
Where is the Crankshaft sensor on a 1998 Chrysler Sebring 2.5 V6?
It is on the top rear of the transmission bell housing.
How do you fix a Chrysler sebring lxi that stalls while driving in same spot?
crankshaft posistion sensor
Where is the crankshaft position sensor on a 1999 Chrysler Sebring 2.5L?
It is on the top, rear of the transmission bell housing.
Where is the crankshaft sensor on a 2000 Chrysler Sebring convertible 2.5 engine?
It is on the top rear of the bell housing.
Where is the crankshaft position sensor in a 1996 Chrysler Sebring JX 2.5L V6?
It's in the transaxle housing.
Where is the crankshaft position sensor on a 1995 Chrysler Sebring v6?
It is mounted on the top rear of the transmission bell housing.
