The fuel filter is normally to the left of the carburetor. To replace it, it is best to wait until you have less than a quarter tank of fuel, and the engine is relatively cool. Loosen the hose clamps above and below the filter, then twist the hose slightly and remove the upper hose from the filter. Now for this next part, you will probably spill a little fuel from the filter. Twist the lower hose (you can rotate the filter if you want), and remove the filter. Some fuel may drain out of the filter, which is why it is better to have the engine cool rather than hot ;)
Inspect your fuel lines to make sure the rubber is not cracking. The original hoses had a cloth covering which hides cracks, so check the ends. Insert the new filter, paying attention to the flow direction arrow which should point upward. Tighten the hose clamps, but not too tight. You should not be able to twist the hose on the filter easily. Start the engine and check for leaks. The first couple times you take it out on the road, it's a good idea to stop and check for leaks again. Better safe than sorry!
no 68 seat tracks are wider than the 69and up ghias
4 quarts in the pan and 1 quart for the filter, so that's a 5 quart oil change with filter.
People have done it but it's very hard. What WILL fit on your Beetle are the disc brakes from a 1969-on Karmann Ghia.
how do replace an accellerator cable on a 1973 bug
In the carb, it's an internal Q-Jet Fuel Filter.
How I have to do for replace a little bulb on the ODO speedometer cable on 1973 Super Beetle ?
To change the thermostat on a 1973 Ford Mustang with a 302 engine, drain the radiator. Locate the thermostat under the upper hose assembly and remove the required bolts. Place the new part in position and replace the hose assembly before filling the radiator.
Defective oil filter or relief valve at the top of the filter housing not opening to relieve excess pressure
None is needed. The car came from VW with hardened valve seats, and by now this specimen has had the heads changed--and all aftermarket heads have unleaded valve seats.
In 1973
1973
If it's a Pontiac 350......and it should be, it is a direct swap. You don't need to change ANYTHING. Pull the 350 out and put the 455 in.