You have two O2 sensors. The most common one to replace is the one on the exhaust manifold on the passenger side. (about $50) Pull off sensor connector plug. Unscrew it. Screw new one in. Re-attach sensor plug.
My car when slow stop engine
Sensor number 1 is the one before the catalytic converter. First off, are you sure that is your problem? There are numerous things that can give you a code for the oxygen sensor. A vacuum leak, a wire burnt on the manifold, and even a bad connection. Be sure before you spend money that you do not have to . It takes a special socket to replace it and the socket can not be used for anything else.
There are two oxygen sensors. One located on the exhaust manifold and one located after the catalytic converter.
where is the map sensor located on a 2005 gmc envoy
No, it can cause you to use and excesive amount of fuel but it will not effect the battery.
The 2002 GMC Envoy typically has two oxygen sensors located on the exhaust system. The upstream oxygen sensor is usually located near the exhaust manifold before the catalytic converter, while the downstream oxygen sensor is typically located after the catalytic converter.
Drivers side exhaust pipe just after the exhaust manifold. Best reached from underneath.
how to replace wheel bearings on 2004 GMC envoy?
Mas air flow sensor
Code P0145 on a 2003 GMC Envoy indicates a problem with the oxygen sensor circuit, specifically for the bank 1 sensor 3. This may suggest that the sensor is reading incorrectly, there is a wiring issue, or a problem with the exhaust system. It's important to diagnose the issue further to determine whether the sensor needs replacement or if there are other underlying problems in the circuit.
fuel level sensor
This will be difficult. You must remove the alternator to get to the themostat housing. While you are there, you may want to replace the Temp sensor too!