take a rensh some directions and FIGURE IT OUT YOUR SELF YOU FRICKEN LAZY BUM
To replace the parking brake pads on a 2002 Volvo V70, start by lifting the rear of the vehicle and removing the wheel. Then, remove the brake caliper and rotor to access the parking brake assembly. Take out the old pads, ensuring to clean the area, and install the new pads, making sure they are properly aligned. Reassemble the rotor and caliper, and repeat for the other side before lowering the vehicle and testing the brake function.
FRONT BRAKE PAD REPLACEMENT Jack up vehicle and remove the wheel. before removing the caliper , be sure to depress the piston into the bottom of its bore in the caliper with a large C- clamp to make room for the new pads. look behind the caliper and you should see two bolts holding the caliper on. remove the bolts, "DO NOT REMOVE THE BRAKE LINE", the caliper should pull free from the caliper mounting braket. DO NOT LET THE CALIPER HANG BY THE BRAKE HOSE". Separate the brake pads from the caliper mounting bracket." Remove the steel slippers from the upper and lower parts of the caliper mounting bracket. After doing the above You should be done with removal to install follow the above steps in reverse. The rear brakes are the same as the front brakes to replace. However the rear brake disc is also a disc / drum that houses the parking brake pads. The parking brake pads are behind the brake disc. you will have to pull the disc off to get to these brake pads. The removal of the parking brake pads requires more time and is a bit more difficult to replace. I would inspect the parking brake pads before removal and replace them only if needed.
how do you replace brake-pads on vw beetle 2002?
the emergency brake pads ARE the REAR brake pads.
How to replace front brake pads on Mercedes s430
remove old brake pads, replace with new brake pads voila!
How much does it cost to replace brake pads on a 1999 Mercedes Clk?
no
Lift the car on a car jack, remove the tire, remove the brake shoe/calipers, and remove the old brake pads. Next, dispose of the old brake pads, put in the new brake pads, replace the brake shoe/calipers, replace the tire and lower the car to the ground.
Lift the car, remove the tire, remove the brake shoe/caliper, and remove the old brake pads. Put in the new brake pads, replace the brake shoe/caliper, replace the tire, and lower the car.
Your bike brake may be squeaking due to dirt or debris on the brake pads or rims, misalignment of the brake pads, or worn brake pads. To fix it, you can clean the brake pads and rims, adjust the alignment of the brake pads, or replace the brake pads if they are worn out.
Lift the car, remove the tire and set aside, remove the brake shoe/calipers and remove the old pads. Replace the old pads with the new pads, replace the brake shoe/calipers, replace the tire and lower the car.