0
Take plastic covers of each side to expose coil packs
Loosen but don't remove rear drivers side bolt and front passenger side bolt from top of plenum chamber.
Remove remaining plenum chamber bolts (this way you don't have to replace gaskets.
You'll have to chock up plenum chamber to get to two of coil packs that have to be removed to expose plugs
Remove single bolt and carefully pull out coil assembly
Remove spark plug using an extension tool as they're buried quite deep
What else can I help you with?
When was Holden VZ Commodore created?
Holden VZ Commodore was created in 2004.
How do you replace the fuel filter on a VZ commodore?
I don't even know. LOL
How do you remove Window Winder VZ Commodore?
How to remove Window Winder Handles from VZ Holden Commodore
What kind of spark plugs fit Suzuki Marauder VZ 800?
Ngk dpr8ea-9
Where is the fuel pump located on a vz commodore?
On top of the fuel tank most probably need mechanic to replace for you.
Where can I get a workshop manual for vz ss commodore?
www.factoryautomanuals.com
Where is the thermostat on a vz commodore?
At the rear of the engine, above the bell housing.
How do you remove steering wheel on a vz commodore?
one word crowbar
Where is the flasher unit on a vz commodore?
Next to the base off indicator stalk
Where do you put a chip on a Holden commodore vx?
i dont know much about the vx commodore, but in my Vz commodore i like to put them in my center console and my coke in the cup holder DANNY!!!!!!!!
How do you remove the window winder of your VZ commodore?
http://forums.justcommodores.com.au/holden-commodore-how-s/5541-removing-vt-vx-door-trim.html
How do you replace vz commodore flasher unit?
To replace the flasher unit in a VZ Commodore, first, ensure the vehicle is turned off and the keys are removed. Locate the flasher unit, which is usually found under the dashboard, near the steering column. Disconnect the old flasher unit by pulling it out of its socket, then insert the new unit in the same position. Finally, test the turn signals to ensure they are functioning correctly before reassembling any panels.
