1. The plenum need to be removed as a recomendation detach the wiring connectors, the PVC hose and the fuel regulator hose, but leave the coolant hoses installed to the throatle body this prevent a fluid mess and having to bleed the cooling system.
2. Remove the 03 ,12mm bolts holding the plenum to the braces.
3. Remove the main bolts/nuts off and stand up the plenum rtaher than taking it off completely.
4. Change the spark plugs and hoses while you doing this to save time and future cost.
Remember to label and bag hardware as you go, small plastic bags are good for this. and will help alot during
The dealers charge and exorbitant amount of money for this job, over $350 dollars parts and labor, cost of good spark plugs will run you about $20.00, and about 1 hour of work at a reasonable pace. No special tools are required only metric tools.
To replace the spark plugs in a 2001 Santa Fe with a 4-cylinder engine, first, ensure the engine is cool and disconnect the negative battery cable. Remove the ignition coil or spark plug wire from each spark plug, then use a spark plug socket and ratchet to unscrew and remove the old plugs. Before installing the new spark plugs, check and adjust the gap as needed, then thread them in by hand and tighten them with a torque wrench to the manufacturer’s specifications. Finally, reattach the ignition coils or wires and reconnect the battery.
I want to know
Get a spark plug socket and unscrew the spark plug and replace with a new one.
through the tire wells
Disconnect the battery, remove the spark plug cables, and remove the old spark plugs. Put in the new spark plugs, attached the spark plug cables, and connect the battery.
Disconnect the battery, remove the boots and wires, and remove the old spark plugs. Put in the new spark plugs, reattach the boots and wires, and connect the battery.
will be either,ignition coil,,or module,,easy to replace
how to change spark plugs on a 2001 expedition
TAKE OUT THE OLD SPARKPLUGS AND PUT IN NEW ONES
Remove the 4 screws holding the top cover. You can then get to the plug wires and the plugs.
there are four spark plugs.
Disconnect the battery, remove the spark plug wires and boots, and remove the old spark plugs. Dispose to the old plugs, put in the new spark plugs, replace the spark plug wires and boots, and connect the battery.