There are 2 small screws or small bolts(1 on each side) at the bottom of it holding it in. Undo them. Good luck it's a tight fit.
You can restart the transmission computer, on your 1996 Ford, by removing the transmission, computer fuse. Keep the fuse out for 10 seconds and replace it to its original slot.
open up the hood and there will be a black box the says fuse box open it and there will be a fuse for you head light to come up and down replace it its prolly blown same thing happened to my dads 95 ford probe
you have to take out the whole fuse box and take off the panelof the bottom of the box...it is bolted in i believe youll have to use a 10mm wrench
To change a 100A fuse in a Toyota Matrix, first, ensure the vehicle is turned off and disconnect the negative battery terminal for safety. Locate the fuse box, usually found under the hood or in the cabin, and identify the specific fuse you need to replace. Carefully remove the old fuse using a fuse puller or pliers, then insert the new 100A fuse in the same slot. Finally, reconnect the battery terminal and test the electrical components to ensure the new fuse is functioning properly.
The fuse for the overdrive in a 1994 Ford Probe GT is typically located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove a cover panel. Check the fuse diagram on the inside of the fuse box cover to locate the specific fuse for the overdrive circuit. If the fuse is blown, replace it with one of the same amperage.
Maybe this will help : http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-ford-probe-gt-v6/
it wil have oth the underhood and the underdash fuse diagram in your manual.
which fuse would cause your brakelights,blinkers,dashliht not to work
In the fuse panel in the engine compartment Relay # 21 is the fuel pump relay on a 1996 Ford Probe ( Helpfull )
driver side fron kick panel
If you want answers about your Ford Probe. Please check out this site: www.probetalk.com and place your question there, you will have an answer within the hour.
You replace the hazard light fuse in a Ford Explorer in the fuse panel box. The fuse panel box is located under the vehicle's hood.