answersLogoWhite

0

You will a lot of special tools as well..

Remove the A/C compressor

Remove the A/C clutch disc and hub retaining bolt.

Remove the bolt.

Remove the A/C clutch disc and hub spacers.

Remove the pulley snap ring.

Remove the A/C clutch pulley.

Remove the A/C clutch field coil.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace ac clutch on Ford F-350 diesel 2003?

trying to replace the ac clutch on my f350 6.0 and the bolt up front seems to be a special one any sugestions


Can you adjust clutch on 1997 f350?

It is a hydrolic clutch does not need adjusting


How many miles can you get out of a 6.0 powerstroke diesel?

2006 f350 6.0 powerstroke. 420,000 miles. Replace injectors and ipr at 400,000


How to adjust F350 Hydraulic Clutch?

Hyd clutch has no adjustment, pump clutch pedal hold down bleed off hydraulic slave cylinder on driver side of trans. If won't bleed replace if bleeds off no air in line & still not better ck bushings on clutch pedal under dash. Hope this helps


Will a 2006 Ford F350 grill fit a 2002 Ford F350?

no changed in 2003


2006 ford f350 fuse panel diagram?

im looking for the fuse number for tail lights on a 2006 F350 powerstroke


How wide is a2006 ford f350 dully?

how wide is a 2006 f350 dully king ranch


Where is the TPS SENSOR on a 2006 ford F350 6.0?

It's apart of the accelerator pedal. If you suspect it's bad replace the pedal assembly as a whole.


99 ford f350 air conditioner?

Try and reword your question so that I can understand what you are asking!!!!!!!!!!!


Where is the fuel pressure regulator located on the ford f350?

where is the fuel pressure regulator 2006 ford f350


Will the door panels on a 2006 F350 fit a 2006 F150?

yes yes


How do you replace a Condenser for a 2006 f350?

To replace the condenser on a 2006 F350, begin by disconnecting the negative battery terminal to ensure safety. Remove the front grille and any components obstructing access to the condenser, such as the radiator and fans. Disconnect the refrigerant lines from the condenser, ensuring to recover any refrigerant properly. Finally, unbolt the condenser from its mounts, replace it with the new unit, and reassemble all parts in reverse order, ensuring to recharge the AC system afterward.