disconnect neg. battery cable. remove bolt, unplug one connector, remove one 13mm nut and remove wires, remove two bolts upper and lower, and its out, sometimes you have to wiggle bottom back and forth to free up.
To replace the alternator in a 1993 GMC Sonoma, first disconnect the negative battery terminal to ensure safety. Remove the serpentine belt by loosening the tensioner, then unbolt the alternator from its bracket. Disconnect the electrical connections and carefully remove the old alternator. Install the new alternator by reversing these steps, ensuring all connections are secure and the belt is properly tensioned before reconnecting the battery.
it isn't easy it isn't easy
Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?
buy some stell brake line and bend it up then place double flare on the ends
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
NO. They are different.
To replace the thermostat on a 1996 GMC Sonoma, first, ensure the engine is cool and disconnect the battery. Drain the coolant from the radiator, then locate the thermostat housing, typically found at the end of the upper radiator hose. Remove the housing by unscrewing the bolts, take out the old thermostat, and clean the mating surfaces. Install the new thermostat, reassemble the housing, refill the coolant, and reconnect the battery.
I brought my Sonoma in for this this morning and my quote was $1900 for the whole deal. $1900 was my quote for my clutch, this is from a Chevy dealer service deaprtment. I have not seen the breakdown of parts and labor.
right under the almost impossible to get to alternator......
About $370 in Minnesota, with a new alternator.
To tune up a 1996 GMC Sonoma, start by replacing the spark plugs and wires to ensure proper ignition. Next, change the engine oil and replace the oil filter for better lubrication. Check and replace the air filter and fuel filter to improve airflow and fuel delivery. Finally, inspect the ignition system and sensors, and consider using a fuel system cleaner to enhance performance.
there is an access panel in the back of the glove box.