0
with a lots of patience....
2.0 I-4 or 2.5 V6?
If its the 2.5 1.put the car on ramps 2. drain radiator fluid3. remove upper radiator hose3. loosen/remove alt. drive belt (loosesn belt tensioner bolt and then move the tensioner up with adjusting bolt, a/c belt similar)4. remove plastic splash shield 5. loosen/remove drive belt for ac compressor.6. remove a/c compressor & support it on a stand but DONOT DISCONNECT A/C LINES 7. loosen alt. bolts (2) and unplug/unbolt wires from alt.8. remove old alt. from car (be careful not to damage radiator as there is not much clearance)
NOTE:
don't forget to refill and bleed the cooling system. you may have to unbolt the radiator supports and remove the cooling fan to gain access to the alt.
also, the 1st alt. I bought was bad, might be a good idea to have your new alt. bench tested before installation, most parts stores will do this for free.
What else can I help you with?
Will a 1997 Mazda 626 transmission interchange with a 1999 Mazda 626 transmission?
will a 1997 Mazda 626 transmission or engine interchange with a 1999-2002 Mazda 626 transmission or engine
Where is the alternator located on a 1999 Mazda 626 LX-v6?
The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.
How do you tighten the alternator belt in a 1997 Mazda 626 es?
There should be a spring loaded tensioner pulley. If the pulley isn't holding the belt sufficiently tight you may need to replace the tensioner.
How do you replace valve cover gasket on a 1997 Mazda 626?
autozone.com has detailed instructions on replacing the gaskets.
Where is the Voltage regulator in a 1996 Mazda 626?
It is built into the alternator...
Could the Mazda designers have made it any more difficult to remove and replace the air filter on a 1997 Mazda 626 V6?
Yes. Yes.
How do you change alternator belt on a 1998 Mazda 626?
To change the alternator belt on a 1998 Mazda 626 you need to first loosen the bolt that is located in the center of the adjustment pulley. Next, turn the adjustment bolt to the left until the belt is loose and can be removed. Reverse the steps to replace with the new belt.
Numbering ignition 1998 Mazda 626?
How do I replace ignition wires on my 98 Mazda 626 2.0L
How do you replace front pads on a 1997 Mazda 626?
if your not a mechanic stop googling ways to fix your car and take it to a professionial.
How do you replace the alternator on a 1993 Mazda 626?
To replace the alternator on a 1993 Mazda 626, start by disconnecting the negative battery cable to ensure safety. Remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting brackets. Disconnect the electrical connectors and the positive battery cable from the alternator, then install the new alternator by reversing the removal process and ensuring all connections are secure before reattaching the battery cable. Finally, re-tension the drive belt and check for proper operation.
Why is your 1997 Mazda 626 not firing?
distributor or coil
How do you remove the alternator on a Mazda 626 1989?
Remove passenger side Rack and pinion arm and slide out Alternator .
