push the front roller against a workbench this locks so you can remove belt.then take a pair of needle nose vise grips and lock on to the black steel bar near the end of it.put the new belt on.push the front roller against the workbench again and pull on the vise grips as you release pressure from against the front roller. this will unlock and spring out the front roller. might take a couple tries. good luck.poor belt change design.
The sanding belt size for the Sears model 113.225930 sander is typically 3 inches wide by 21 inches long. Be sure to check the specific model's manual or manufacturer's specifications for confirmation, as variations can occur.
How do I obtain an instruction manual for Proform model 831297761 and safety key?
Yes they did.The sears model number was model 54.This was a Winchester model 94.
I happen to believe that your sears model 460 could have been made by marlin.The marlin model 56 should be your sears model 460.
I have a sears pool table Model # 440-26680 What is yours?
Your Sears model 200 shotgun was made by Winchester.The model 1200 Winchester is the same firearm.
Your rifle was made for Sears by Marlin, and is a model 336C.
Winchester Model 1200
The Model 14 was catloged in 1963 and 1964 http://www.histandard.info/PDF/Sears%20Shotguns.pdf
need a diagram of sears model 66m shotgun for takedown
The Sears model 2200 is the same as a Savage Model 80 Series A.
Daisy. I believe it may be a model 25 made by Daisy for Sears