Probably under vehicle - follow the fuel line from the fuel tank
Try under vehicle along fram rail --follow fuel line from tank
ford fuel line disconnect tool. available at your local auto parts store.
To replace the fuel pressure regulator on a 1985 Crown Victoria, begin by relieving the fuel system pressure by removing the fuel pump relay and starting the engine until it stalls. Next, disconnect the battery and remove any components obstructing access to the regulator, typically located on the fuel rail. Unclip the vacuum line and disconnect the fuel lines from the regulator, then remove the mounting screws to take out the old regulator. Install the new regulator in reverse order, ensuring all connections are secure before reattaching the battery and testing the system for leaks.
try following the fuel lines from the gas tank it should be along the frame rail in line. You may need an fuel filter tool to remove the clips holding the filter in the line. hope this helps
If you are talking about the steel brake lines, most likely the rear lines, then replace both from front to back.
If I had to replace a fuel line I would get a replacement out of a car in a wrecking yard and install that.
Depending on the trim line and options about 5500lbs
Most likely the clamp on the fuel line has worn through the line - check the fittings and perhaps replace fuel line
It is located under the car, in front of the RR wheel, on the inside edge of the frame rail. It has an inlet and outlet line. one on each end.
No you do not.
Follow the instructions on Youtube.