answersLogoWhite

0

Look under the column, there should be a hole with a recessed release button. Put the key in and turn it back while pressing the release with something small enough to fit in there. I used an awl and it was really easy These instructions actually refer to replacing the Ignition Lock Cylinder. Replacing the actuator usually involoves pulling the steering wheel.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace the ignition actuator or rack on a 1995 Chevy astro?

what is an ignition actuator i work on Chevrolet and have never heard of it are you talking about the switch


How do you replace ignition switch actuator rod?

To replace the ignition switch actuator rod, first disconnect the vehicle's battery and remove the steering column covers to access the ignition switch. Disconnect the wiring harness from the ignition switch and remove any screws or bolts securing it in place. Carefully pull out the old actuator rod and replace it with the new one, ensuring proper alignment. Finally, reassemble the ignition switch, reconnect the wiring harness, and replace the steering column covers before reconnecting the battery.


How do you remove the ignition switch actuator rod on a 1995 Mercury Cougar?

To remove the ignition switch actuator rod on a 1995 Mercury Cougar, first disconnect the battery to ensure safety. Then, remove the steering column cover and the ignition switch assembly. You should see the actuator rod; carefully detach it from both the ignition switch and the steering column, taking care not to damage any surrounding components. Once it's free, you can replace or service the actuator rod as needed.


Where does the actuator rod fit on ignition switch?

The actuator rod fits into the ignition switch assembly, typically connecting the ignition key cylinder to the ignition switch itself. When the key is turned, the actuator rod moves to engage or disengage the electrical contacts within the ignition switch, allowing the vehicle to start or turn off. Proper alignment and installation of the actuator rod are crucial for the ignition system to function correctly.


How do you put the actuator rod back into the ignition switch?

To reinsert the actuator rod into the ignition switch, first, ensure the ignition switch is in the correct position, typically the "off" position. Align the actuator rod with the slot in the ignition switch, and gently push it back into place until it clicks or fits securely. If necessary, refer to your vehicle's service manual for specific instructions related to the make and model. Finally, test the ignition switch to ensure proper operation.


How do you replace ignition switch with no keys?

You do not need a key to replace the ignition switch.


How do you replace the starter switch on a Ford 350 Econoline Van not the cylinder switch where the key goes but the switch the actuator activates?

2 screws on the opposite side of ignition unplug the switch dash board cover off


How do you i install actuator rod back on ignition switch in my gmc suburban?

To reinstall the actuator rod on the ignition switch of your GMC Suburban, first ensure the ignition switch is properly aligned and secured in place. Next, insert the actuator rod into the switch, ensuring it fits snugly into the designated slot. Then, confirm that the rod moves freely when the ignition key is turned. Finally, reassemble any surrounding components to complete the installation.


How do you replace the ignition switch on a 2005 Chevy Equinox?

how to replace an ignition switch for 2005 chevy equinox


How do you replace the ignition switch on a 2000 Ford Expedition?

How do you replace the ignition switch on a 2000 ford expedition?


Replace ignition switch for 1993 Buick century?

Replace ignition switch for 1993 buick century?


Do you need to replace the ignition lock cylinder when you replace the ignition switch on a Pontiac Sunfire 1999?

No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.