0
The ignition switch is located on the steering column about 18 inches up from the floor on the steering column. Simply remove the 2 screws and when you put the new one on you may have to adjust the switch back and forth until it starts and runs when it is supposed to.
thank you for the answer to my question but i believe it to be wrong. i have done this job before & remember having to take the steering wheel off but cannot recall what i did after that.i do believe gmc had two different models in 88 so that could explain the first answer i got.thank you
1.Remove the horn cover, remove the horn assembly (usually 3 screws & a wire that pushes & twists to remove). 2. Remove silver 3 point clip on the center post, remove 13/16" nut. 3. Use steering wheel puller to remove steering wheel. (make sure steering wheel is positioned where you can remember it). 4. Compress black lockplate with a lockplate tool. Remove retaining clip with small picks. Remove lockplate. 5. Remove hazzard light switch on outside of column. 6. Remove white turn signal assembly (3 screws), gently pull out a few inches, and move away to the side. 7. Remove brass electrical wedge that goes into the lock cyliner inside of the column. 8. remove screw (and plate if applicable) that holds in lock cylinder. 9. Pull out lock cylinder. Replace.
What else can I help you with?
How do you replace ignition switch with no keys?
You do not need a key to replace the ignition switch.
How do you replace the ignition switch on a 2005 Chevy Equinox?
how to replace an ignition switch for 2005 chevy equinox
Replace ignition switch for 1993 Buick century?
Replace ignition switch for 1993 buick century?
How do you replace the ignition switch on a 2000 Ford Expedition?
How do you replace the ignition switch on a 2000 ford expedition?
Do you need to replace the ignition lock cylinder when you replace the ignition switch on a Pontiac Sunfire 1999?
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
Ignition switch will not turn Replace?
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
How do you replace the ignition switch on Lexus es300?
remove ignition switch 92es300
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do you replace ignition switch on a 2000 silverado?
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
How do you replace a 97 Camry ignition switch?
1997 Toyota Camry ignition switch removal
How do you replace 2006 Laredo ignition switch?
To replace the ignition switch on a 2006 Jeep Laredo, first disconnect the battery to ensure safety. Remove the steering column covers by unscrewing them, then locate and disconnect the wiring harness from the ignition switch. Unscrew the ignition switch from its mounting and replace it with the new switch. Finally, reassemble the steering column, reconnect the battery, and test the new ignition switch.
How do i know which part of the ignition switch to replace if car will not start?
The ignition switch is one unit and you replace the entire thing. Do not confuse the ignition switch with the key lock tumbler. They are two different things.
