You can go to Autozone.com and it will give you directions.
help
How do you replace power steering belt on 2003 Mazda protege ?1.6
It's built into the power steering reservoir. To replace it you need to replace the whole reservoir. Fortunately, this is an inexpensive part... ($30).
To replace the power steering pump on a 2003 Monte Carlo SS, start by disconnecting the negative battery cable and draining the power steering fluid. Remove the serpentine belt and then unbolt the pump from its mounting bracket. Disconnect the power steering hoses and electrical connector, then replace the old pump with the new one, reattaching the hoses and bolting it back in place. Finally, refill the power steering fluid, reconnect the battery, and bleed the system as necessary.
Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.
To replace the power steering pump on a 2003 Windstar, first, disconnect the negative battery cable and drain the power steering fluid. Remove the serpentine belt and then disconnect the pump's hoses, taking care to catch any remaining fluid. Unbolt the pump from its mounting bracket and replace it with the new pump, reattaching the hoses and serpentine belt. Finally, refill the power steering fluid and bleed the system to remove any air.
very carefully
The 2003 Kia Sedona is 6 ft. 2.6 in. (74.6 in.)1 one-touch power windows wide.
Lift the Acura. Drain the power steering fluid. Disconnect the steering joints from the power steering rack. Unbolt the race and remove. Install the new rack and connect the steering back up.
left side of the dash under the steering wheel
no, there are no power steering filters.
It would depend on your level of competence.