i used one ratchet swivel, 2 long extensions, and also took off the interior shroud for better access, can be done in 15 min. have to go through the wheel base to get best access. hint get a pair of welder gloves(the big ones) that way if you need to check wires after running it or you are doing this while the engine is still warm the gloves allow you to work without getting burned.
Replace the spark plugs and plug wires. Replace the distributor cap & rotor. Replace the air & fuel filter.
coil pack bad, or wires could be faulty/old should replace them, or the sparkplug itself could be bad try replacing plugs & wires and start from there
Change the spark plugs and wires... Change the spark plugs and wires...
My 4.0 awd aerostar does not have an egr. If you have pinging,and done all the usual tune up stuff, try putting in spark plugs from the 3.0 engine. the different reach range cured my pinging!
how do you put spark wires in the right place on the coil pack on a 1995 Chevy cavalier2.2 frank
Follow the spark plug wires, they will lead you right to them.
they are on both sides of the engine just under the spark plug wires.
The 10.2mm spark plug wires are the wires that are only needed for the engine to run on a 1995-2005 Chevy Cavaliers.
Yes... Where all the spark plug wires go into the same spot.Yes... Where all the spark plug wires go into the same spot.
Screwed into the engine. Follow the spark plug wires.
Take old spark plugs out put new spark plugs in
Answer I can only assume that your question is How do I change the spark plug wires on a 1995 Buick and how do I know where they go? You take one wire at a time out of the top of the engine, and trace it to the distrubuter. Replace that wire and continue replacing each wire the same way as you did with the first one. When you are finished the car should run properly, but while you are changing the wires why not change the plugs too.